Separate names with a comma.
Some features disabled for guests. Register Today.
While walking this morning I was thinking about how to keep the gears inline since I had a problem with that large drive gear. I had the bright...
After test fitting & moving the gears around, that big drive gear wobbled too much. I played with making the wheel space shorter to get a smaller...
It was fairly easy to make an optional 10mm taller plate, so I went ahead and did it while the design is fresh in my head. I will still use the...
Before reprinting these parts, I put the assembly together & looks pretty good. The only thing I see is the drive gear attached to the motors is...
I found a Drawing Robot pen mount design that is better than what I am using & am going to rework that idea into my design. It uses 3mm rods from...
I created the Ryobi PS Mount using DIY battery powered PS as a starting template. I plan to use his instructable for making this. I just needed...
I attached a zip file to the files area that contains STL files of all the design files, BOM text file & the Marlin-2.0.4.4 firmware Configuration...
I had thought about looking at that to control the printer, but since the MKS Gen 1.4 board currently doesn't have WiFi, I was using octoprint...
Early on in this design, I realized I can create patterns in a shallow pan of sand or baking soda in this case. If you are familiar with the ZenXY...
I got the servo motor working yesterday & was able to finally do some test drawings. I created the initial gcode with Estlcam & edited the file...
I increased the offset of the belt clamp & have it pretty close to straight on the idler side. I will either change the 16T to a 20T on the motor...
I think after fine tuning this design I will finish the version with geared wheels as it makes more sense economically if it works just as well...
After pulling the Hermera model into my design I realized it wasn't going to work as it was so I spent a little time on redesigning the mount &...
It is alive & first movements with the TPU went surprising well. Here is short video I made of it. [MEDIA]
Let me take a look at it with a model of the Hemera attached in Fusion 360 first to make sure it fits ok. Will see if I can upload it in next...
Think I might have caused my electronics problem with static. I have been using a metal feeler gauge for years without any problem for adjusting...
I seem to have found my thermistor problem on my 3d printer. It was not the thermistor which I didn't think it should be since I just changed...
Since I have come this far with the belt idea, I will give it one more version to see if it works. I have some smaller Diameter idlers (18mm OD)...
Thanks for the suggestion & thought it was a great idea until I looked at my machine. Unfortunately that would put the drive pulley on the smooth...
Mark you were right about there not being enough teeth to grab the belt. I was able to get it working today & it did have a hard time grabbing...
