Separate names with a comma.
Some features disabled for guests. Register Today.
Oops, I forgot to click the Post Reply on this message on Sunday. Not sure I will put this on a magnetic bottom plate as someone on the facebook...
Test print with these magnets seems quite strong, so I figured out a way to incorporate these without buying the flat ones. I just put them...
I have been working on making a z-probe mount to fit where the router fits to do autoleveling across the whole bed with bCNC. If I understand...
The dust boot looks pretty good on my machine, so I uploaded the design to thingiverse. Remix of Bosch Colt Dust Boot to make one part by GeoDave...
Since you are waiting until the weekend to print it, you will probably want to wait for this updated version. I will upload it if it works better....
Thanks for the file. I will probably cut one of these eventually when I get around to cutting aluminum on this machine. Meanwhile I am playing...
After watching the video with the link at the bottom I started thinking of a way to make something like this easily. My idea went from a little...
I found the problem after a comment from the xPRO thread. There was a coating on the router bit that was not getting the connection. I also...
I am currently using the openbuilds control software. It apparently was the coating on the endmill. I tried running the G38.2 code & connected...
Maybe I have some connection not right then since it hit the bottom the last time I did it. Is there a status command I can type while holding...
Is it possible to use the (D3) Z-Probe pin & GND connection for using the Z-Probe? The video I saw used a couple of pins in the 10 pin block just...
The author of that dust boot design has a router is a little different than mine which was my problem. I tried the Z probe & timed out after...
I made my z-probe cable today & printed a Bosch Colt Dust Boot that I found on thingiverse. It has a couple of limitations for me that I mention...
Success. I ran a simple 2 hole cut for the T-nuts today & it worked perfectly with just that 5mm clearance setting. Those wheel covers worked...
That idea for the plastic C-Beam jig worked pretty well. It is also less likely to cut or hurt your fingers while adjusting those wheels with a...
After pondering my Z axis problem, I think it is probably the inside mini wheels on the z-axis that are too tight now & the motor slipped on...
I did another test cut after adding the wheel protector covers & took a picture of where all the dust was. A little dust still got to the wheels...
I got this wheel protector idea to work pretty well. I was making that connector part between the C-Beam & 2020 too complicated. I realized this...
I test fit a 25mm long part or should I say 25mm High part as I had to print that way. I was trying to avoid printing it on its edge, but seems...
I did my 1st test cut on Sunday by pocketing a hole for 1 t-nut & could not figure out at 1st why the flange pocket cut did not work right....
