Separate names with a comma.
Some features disabled for guests. Register Today.
I would refer to this for hard and soft limits gnea/grbl. I do not currently use limit switches. I always start cutting in roughly the same...
Did you already buy the xPro? Or are you in the research stage.
I am confused. Maybe this is the case, but shouldn't your z0 be the top of your work surface, or if you choose, the top of your spoilboard? Then...
How long were the Cbeams? I am curious. As I mentioned before, when I purchased them before, I believe they came longer than listed because the...
The external drivers like the TB6600 (good) or DQ542MA (better) would be a much better option. They can still be used with the Uno board. I use...
The A4988 Stepper Motor Driver do not have the amperage you may require. They are made for 3d printers with much smaller motors. I wish they...
I believe all extrusions are shipped a little long and the end user is supposed to square them up. I thought it used to say that in the product...
I am not sure why you get this. When I drew up something similar, it looked like it should. There is a great manual for sketchucam if you click...
Hey Stargeezer, the person that posted that picture has not been on her for the last 12 weeks. So, not sure how soon he will get back to you....
Here is their information for their product. synthetos/g2
I assume you have this correct since you calibrated, but just to eliminate something for certain, when you type G0 x100 in UGS and send the...
Limit/homing switches would be helpful for you. A temporary work around that could be done, is to pick your X and Y zero point, and always return...
I can't answer your questions except to say it is free to download and try it to see if it works with the G540.
Are your switches NO or NC? For what it is worth, I have been cutting with mine for a couple years and I haven't bothered with limit switches....
What controller board/driver combo?
A genuine Arduino Board with a screw shield similar to this one. It is not a necessary add-on, but it made it easier to connect up the wires.
If I understand correctly, you are having trouble downloading and opening Grbl Panel. I did too. Here is what worked for me and others. very,...
You should not have to shut it down. One of the things with Grbl Panel, and other senders, is if your spindle is at x150 (or anything greater...
Yes. That is great, but all those questions I asked would help answer the question as to why your machin is off by a factor of four and apply to...
What made you choose 26.667 for your $100 and $101? Because that is nearly a factor of 10 low for an 8 mm pitch screw at 1/8 microstepping. Also,...
