Separate names with a comma.
Some features disabled for guests. Register Today.
Can you run a 3D printer with Mach 3? I do not think you can. I could be wrong. Personally, I can see doing most of what you want with one...
Where do they go? I am curious because I did not see them listed in the designer's BOM in the parts list tab.
My only experience with linear rails and bearings is on my 3d printer. The linear ball bearings (made in China) that came with it are crap. I...
I am a visual learner so, here are a couple videos that made it easy for me. As mentioned, probing is a quick and accurate way to zero the z...
I apologize, but I couldn't tell if you had these questions in the past, or actually are asking them now. So, if you or anyone still has these...
With an M8 with 1.25 pitch at 1/8 microstepping, 1280 is the steps/mm according to this RepRap Calculator - Prusa Printers But, I do not know if...
I ordered a few of the wheel kits from the "far east" out of curiosity. The shims were not 1mm. They were all less than that. Also, about half...
I like the higher voltage for the steppers, but you are probably right with it not being too much of a load. That being said, my X axis is 1500mm...
Here is how I did it. First, I calculated my steps/mm (theoretical) with my lead screws which were supposed to turn 1/2 inch (12.7mm) per...
I would think 12 volts will be fine. I have a 12v laser, but a 24 v supply. I found a small 12 v power supply with the scanner I salvaged for the...
[ATTACH] I just made the switch to Estlcam yesterday and am about to cut a new 3d printer plate out of aluminum with my Ox variant. I plan to...
Are you sure? The board comes with the default setting of 1/8. With the 14 tooth pulley - which I believe the Acro comes with- at 1/8 you would...
What is your microstepping set at? 5. Troubleshooting · Spark-Concepts/xPRO Wiki · GitHub For your x and y, your microstepping jumpers are...
Cool! That should work.
You could get yourself a block of delrin and make your own antibacklash nuts. I did this for 1/2 inch lead screws and it works great.
Or you could try to use surface scanning with Estlcam.de 2D / 3D CAM Software und CNC Steuerung...
If you are using GRBL read this Home · gnea/grbl Wiki · GitHub All of it...a couple times...refer to it often. I have been up and running with...
For wood, I am generally running about 2500mm/min with a single flute endmill at 10000 rpms. DOC was probably around 2-3 mm.
I used this: https://www.homedepot.com/p/Southwire-500-ft-18-2-Shielded-Security-Cable-57573144/202316266, but I bought it by the foot instead of...
Cool! I made that paddle, too. I used the band saw, table saw, spokeshave, random orbital sander and router table. I didn't have my CNC back...
