Separate names with a comma.
Some features disabled for guests. Register Today.
Basically, you loose the width of your Y plates. As long as the bit is cutting between the front and rear edges of these plates, you maximize your...
AAACK! I dropped my old laptop. It wasn't the first time, but it ended up being the last. Apparently, it isn't recommended. It would not fire...
I do cut aluminum. Here is a video of it cutting aluminum plates for my eggbot. [MEDIA] [IMG] I am getting ready to cut a plate for a downrigger...
Releases · gerritv/Grbl-Panel · GitHub Download zip, extract all, open GrblPanel-Release-1.0.9.13 Folder after extracting, and then open the...
Put a cutter at each end and you can cut two identical parts at once. :thumbsup: It would help balance it, too.
I am sure the spindles are quieter, but my Makita is not that loud. I cut most everything at 10000-15000 rpms and I can have a normal conversation...
Although, either way I think you are going to get the max you can out of it without actually shrinking the width of the Y gantry plates. You can...
It looks good, but...now it doesn't utilize the entire cutting surface to the front. Unless, of course, you are using really large diameter...
You could build everything flat like a normal ox and just build a box (or use solid layers-much heavier) with a spoil board on top to bring it up...
I am curious where you got the 5% error from. Or did I miss it in the discussion?
Yes. I use straight a lot when cutting wood because I have old router bits.
It may because you are using an upcut but and it is tearing out the wood. Some people use downcut bits to avoid this tear out.
Great find on the air hose/mister.
First, I got rid of the DRV8825s and went to the DQ542MA drivers. I assume that is what you meant, but I just wanted to clarify. 1) I use one...
Thanks. $40 is reasonable for software that works. I will quit thread-jacking now.
The Voxel Ox build uses mostly off the shelf OpenBuilds parts so If you did have to pay for a few printed parts, it would be cheaper. Some of the...
Jonathan did a great job answering your questions, so I will just add a couple thoughts to it. The z-touch plate is a good idea, but I have found...
I was in the same boat as you. I really wanted to build one, but I didn't have one to make the parts. I gave up and bought a highly rated sub...
I just got mine in the mail today! I have similar questions so I will study the answers. WIldbill, can you share the tips you sent Paul with me?...
I thought the same thing when I cut my plates on a table saw and scroll saw then drilled the holes with my drill press. Time consuming and fun,...
