Separate names with a comma.
Some features disabled for guests. Register Today.
Here is a free Instructables class Electronics Class That has a soldering lesson. Instructables is a great resource for fun an interesting stuff.
I have only used GRBL panel, but it works for z-probing. I have not tried any other probing like edge detection.
I had the same issue with the Z dropping. Then after switching to the 255 setting, my cnc shield started getting hot. I had to install better heat...
You probably already know this, and I do not know much about TinyG, but there may be a spot to put a jumper to set the microstepping. The CNC...
Is there a chance you put the wrong distance in your steps/mm setting? For example, you want 1/8" microstepping and set your machine for that,...
I do not know much about Tinyg so I may be wasting your time, but on other control boards (at least the arduino based ones I am familiar with)...
The first thing most people do, and personally I think it is necessary, is surface their spoilboard with a larger bit like this:...
Hmmmm... I like this table saw fence. I may make one, but maybe add steppers and a control panel. Zero it against the blade then input the width...
+1 on the Whitesides. I have a Whiteside V-bit for v-carving and love it. It is also helpful for calibrating the CNC due to the pointy-ness of...
Thanks. I am linking this in my build since people have asked me over there. I try to send them your way since you do a better job explaining it....
This was just across the river from Astoria at Dismal Nitch. I think Lewis and Clark either ran out of happy names, or were just sick and tired...
Close. Good eye. It is a dry suit, but for kayaking. Well, technically, it is for kayak fishing. I get bored "just kayaking", but at least if I...
After cutting with this thing since August, I figured I should probably calibrate it. It seemed to cut fairly accurately, but I figured this...
No, I have not noticed it get hot. I figured it must have something to do with cooling, but was curious if that warning came with others. I will...
Has anybody looked at how low they can run their routers for extended periods safely? I have the Makita which will go down to 10,000 rpms. This is...
They are relatively inexpensive on Amazon.com: aviation connector
I have mine working, but a better explanation for others may help. I may have confused people due to some photos I took while wiring mine and then...
That wire has been removed. I did not catch that in the photo. These are old photos from prior to finalization and putting it into the box. I will...
[ATTACH] If you look close, pin D8 has En written on it in sharpie. It is actually the 9th pin because on the digital side, the Arduino starts...
I use GRBL Panel. It works well for me. You had me second guessing myself, so I looked closely at my picture above and noticed no wire in the...
