Separate names with a comma.
Some features disabled for guests. Register Today.
Sorry it took so long. I am using 0.9i.
Beautiful. I am curious what bit and what feed rate/depth of cut/step over you used. I too have a lead screw driven Ox variant, so I am always...
I believe that it way to small. I used this on 15 X 30 mm both my x and y axis. 15mm x 30mm Black Plastic Semi Closed Drag Chain Cable Carrier 1M...
[ATTACH] I forgot about upgrading that.
If you want an all in one, buy the xpro, plug in your motors and computer and you are done. if you want, you can add limit switches . the xpro...
I updated to the most recent GRBL Panel version and when I look at the settings tab nothing shows up. I can not edit anything either. However, I...
Hmmmm... I made two versions of the anti-backlash nuts in Fusion 360. 1 for 3/8 inch acme rod and 1 for 1/2 inch acme rod. The more I use Fusion...
I have found this to work best as well.
I need to book mark this post. Great info. Thanks.
No problem. You are welcome. I haven't done it yet myself, but I would like to give that a try, but the software is a bit pricey.
You also need to figure out which wire is paired with which. Pick a wire. Hold one of the other three to that wire. Try to turn the motor. If it...
My CNC, as well as all the CNC routers I have seen built here have the ability to move all 3 axis at once. Vectric makes some powerful software...
Do you have a Home Depot nearby? I purchased 18-2 and 18-4 shielded stranded wire by the foot. Or, you can buy it by the roll. I am sure Lowe's...
Wow! That stuff is expensive. Do you have metal yards near where you live. I pay $3.50 per pound at a metal yard. That plate would cost me about...
I had the DRV8825s and I switched to the DQ542MAs. I noticed a difference because not only did I get an increase in available amperage, but I was...
Wow! I don't know if it is legal to have a shop that neat! Very nice.
I really want to build one of these. It looks awesome! I am curious as to what materials you plan to cut with this laser.
How deep were you cutting? The Y uses two motors, the X one. Maybe the A4988s can't handle the depth you were cutting with one motor which is...
I use GRBL Panel (Home · gerritv/Grbl-Panel Wiki · GitHub) as my control software. I have never tried any other because I set it up and it worked...
On my cnc, if I attached the wiring to all the drivers the same way (by color ) my x would run the wrong direction. But, I use individually...
