Separate names with a comma.
Some features disabled for guests. Register Today.
Hmmm... My spindle goes all the way to the front edge of my CNC build. Maybe I should mount a head and tail stock at the front. I have the...
I got a little more done today. I soldered on the additional screw terminals to the screw shield As pictured on the previous post. The top looks...
Sounds great. Of course I use the Makita so I may be biased. ;)
Ok, so I didn't get much done on making my new electronics enclosure, but I did get the grid of holes drilled and countersunk to attach the top...
From 1st page of grbl panel thread. It has worked for me.
I went back to the first page and found this by GerritV:
If I remember right, you click on the setting you want to change, make the change, then double click. The setting should now be saved. It has been...
Looks great. Thanks for all your hard work.
Oh, and I bought the Elaire collet set, too. They seem to work very well. Elaire Corporation
I love my Makita! It is so quiet. I have it turned down as low as it will go while cutting wood and it just hums. Now if only the shopvac wasn't...
I drilled additional holes into my shaft couplers then into the shaft a bit, and did the same to the acme screw side. I tapped these holes with an...
I cut most of my plates on the table saw with no problems. I did not use any lube.
I had a similar problem because my steppers were not energized during the entire run. The solution was changing grbl settings. David the Swarfer...
I found the drag chain makes life easier. If the parts store doesn't carry drag chain, I have had great luck with this one. Amazon.com: 15mm x...
As far as I am concerned, you have until October 1st. However, there seem to be many others that may start beating down your door soon. ;)
End of year money being spent today at work. I was hoping this kit would be available. Someone I work with was asking me to purchase a small CNC...
Ha! I just got them today. They look nice.
If you order from Elaire, you must be patient. I ordered a set of 1/4, 3/16, and 1/8 collets almost 3 weeks ago and they still have not come. If...
I ordered from here Kodiak Cutting Tools® - Premium USA Made Cutting Tools because I needed some longer end mills (4"). They sell on amazon with...
Yeah, I used cutting fluid on all of mine. I also used it on all the holes I drilled and it really helped when I was drilling and tapping into my...
