Separate names with a comma.
Some features disabled for guests. Register Today.
Not specifically sure as I've never built one but looking at the model the X-axis gantry smacks the side plates at 48" and you have to leave a bit...
Sorry, misunderstood the question. A pdf file from Openbuilds is attached which gives full dimensions but you might want to verify with the shop...
It takes a 16mm bearing so the answer must be 16mm.
Looks good. The spacing between the uprights is not the issue here. The problem is the interface between the aluminum and steel rails. (ref:...
Consider a chunk of 6x2x1/4 rectangular aluminum tubing. Second suggestion would be based on the built up concept above but skip the C-Beam in the...
The following should give you some ideas but if all you do is cut a 63mm plug with a 32mm hole in it that may work too. Just be sure to carry the...
As you have a CNC system you could always cut a fitting…
Can you provide a drawing of what you’re trying to achieve?
Contact the parts store at http://support.openbuilds.com/support/home. Not sure how much help they can offer as this is a second hand system but...
The power supply or the power supply fan?
Yes and Yes. And as far as the lengths go the Openbuilds parts store will cut them for you. Just specify in the comments section of the order....
Attached is a Sketchup file of the concept. It's fully developed but not fully detailed. You'll need to visualize all the screws going through the...
Thanks but a good square on photo of the side would be more helpful. I need it to get the front edge height and as I can trace it, it'll save a...
Thank you. If you would please also provide a good square-on photo of the side with dimensions (WxH) that would be helpful. Thanks.
I looked over the assembly instructions this morning and this seems fairly simple based on what you have to work with. As I said previously I...
20x20 might be possible if you use a light enough spoil board. I’d throw you some design suggestions but I’m 1500 miles from my computer and I...
The problem you're facing with the Millright system is it only uses 3 stepper motors and they're more than a tad bit on the weak side. Trying to...
What size router/spindle are you using and is the problem worse toward the middle? You may have reached the torsional stiffness limit of the beam...
Read through the High Z Mod for Lead CNC. Within the first couple of pages you see how to reverse the axis beam to where the whole beam moves...
Easiest solution is just to add another mount bracket. [ATTACH] Shy of doing that though, keeping the extension distance of the router below the...
