Separate names with a comma.
Some features disabled for guests. Register Today.
I have ordered some more shims from amazon. :) Better to be safe than sorry for the princely sum of £1.69 Hopefully going to have everything but...
Ok, it certainly sounds like you have more experience than me :) In that case 16 more shims will be needed. I can't say I've noticed this...
Why would you want to though? The lip is an effective way of stopping the bearings rubbing and it only contacts the non moving part of the...
The washer is literally sliding around inside the bearings because the delrin lip is bigger than the shim. It might have limited use, but only...
Is the point of the shims inside the wheels for friction reasons or simply for spacing. I haven't used any inside the wheels because they didn't...
If you use the low profile screws then you don't need to extra spacers on the two y gantries. I also think the x is fine. (but I haven't attached...
Is that including or excluding the one that comes in the bag with each wheel? I have only one on each wheel of my x-axis gantry, and only one on...
Actually not all extrusion is metric, but it makes the sums a lot easier. And in the UK we technically have imperial and metric, but we are slowly...
I would guess because all aluminium extrusion, even in the US, is metric. That and it is obviously an easier format to work in :)
no problem, ask away.
The following is true:- OpenBuilds have built a Routy and it is complete, the photos document the build, along with the skp file Not all of the...
The parts list is not complete, and I recommend you read this entire thread before considering purchasing anything. You need to research this...
The M5 10mm are too long and will foul on the center of the V-Slot. 8mm is right. You are missing M3 8mm screws, which you need 4 of for mounting...
Well, the m5x8mm are on you, because they are in the parts list. But whatever, if you are bothered then YOU provide a parts list. It's perfectly...
The way I see it, if you are looking for a ready made kit with nothing to do but follow the instructions then go get a shapeoko.They are cheap and...
volunteer is the key word. Reading the whole thread gives a good indication of the missing parts, and a large number of the parts are commonly...
By part 2 do you mean the rails for the y axis wheels in step 2?
Double t nuts at the motor plate joins. I used 2 hole joining plate instead, which works fine and is probably stronger, but you will need longer...
6mm might work, it would only give you 3mm overlap on the motor (3mm plate thickness). 8mm are easy to get on amazon or ebay in small quantities....
It think 35mm will fit? (just checked, 35mm is the perfect size) Also, you will need to reuse some of the spare spacers that you replaced with...
