Separate names with a comma.
Some features disabled for guests. Register Today.
Take a close up pic of the endmill from the cutting face end please, and tell us what your pass depth and stepover was
Our stock lead machines does both those tasks perfectly, so they would serve as good inspiration of what it takes, solid reference designs LEAD...
For proper confirmation (and backing should it go wrong) get the VFD Supplier's advice (they would be better able to tell if their product can do...
If its too high, fault indicator will light up. Too low and motor will stall under normal use. Factory default is good for our NEMA23s. It's a...
Depends which of the causes / possible 3rd party parts as mentioned it ends up being, to make that call, you'd have to -help narrow down a bit by...
See docs:blackbox-x32:currentadjustment [OpenBuilds Documentation] - fault indicators are discussed in 2nd half of page. Skipped current settings...
Best to revert to / compare against the backup you took when it was working, to see what has been changed
Always (: post it up as a Build (: https://builds.openbuilds.com/builds/submit-new-build
Speed itself shouldn't cause that, more likely something moving that shouldn't (check wheel adjustment, make sure everything is tight, no unwanted...
BlackBox can do max 3.2A RMS, so those motors will be quite underpowered on it. External drivers not supported (BlackBox is a plug-and-play...
Sounds like too much EMI from plasma. Is it a HF start type by any chance? You should be using a Blowback [MEDIA]
That rules out the signal/settings - please contact JTech for assistance
1) Make sure machine JOGS correctly first (same directions as arrows on buttons). If thats not correct, correct Direction Invert in Grbl...
Checkout OpenBuilds Actuator Test Rig and in particular (on the first page, just direct link)...
And in the real world, thats usually either incorrectly wired (loose terminals or the like) or forgot to enable Hard Limits/Homing in Grbl Settings
Collision: Hit switch head-on [ATTACH] Roll Over Passes by the switch, pressing the roller as it goes, can move beyond switch (but stops...
**applause**
The link still works, just click on through as instructed onscreen Please do read the textual content of the documentation too, especially with...
Connections would be covered in their documentation but essentially all lasers just take a PWM signal from the controller, and power. Generically...
Yes, but beware to not connect the 3.3v pins to higher voltage devices (like a relay with a 5v pullup, or a motor driver with stray voltage on the...
