Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks for the help. I just tested my machine at 12,000 rpm @ 1200 mm/min and at 17000 rpm @ 2400 mm/min, both of which eliminated my chatter and...
I have been using ChatGPT 4.0 to help me setup speeds/feeds and it tends to push on the need to hit certain chip loads. ChatGPT is recommending I...
Unsure on the finish in the desending area, I will cut a new part to test and report back. I use Vcarve for my cut files, I am running a seperate...
I will get it slowed down and see how it goes. I have the tool stick out where I do to reach the bottom of the bed.
I am cutting into Hickory in the above example but I am seeing this issue with walnut, oak, and even plywood (to a lesser extent). Parameters:...
I have been trying to chase away the chatter I am facing with my machine for a while now but am having no luck. Posted are videos of the machine...
I am posting this issue to link to another forum, but if anyone is familiar with 3d printers and/or the Taz6 lulzbot I am having an issue I need...
Update for anyone who finds this thread later, I was digging through another CNC forum and found that if your Router is placed with the majority...
Need some help finding the cause of my bits chattering only in the Y+ direction (no chatter in the Y- direction). I have a fresh Freud 75-102...
I got my interface set up today to run a job so that my laptop would not be tied up for 6 hours on the job. After some issues with the naming...
Bumping this post for anyone that might have missed it but could have inputs.
Thanks for the input, I ordered a guage pin from an earlier suggestion.
This is a perfect example of the missalignment issue I mentioned at the top of this thread. When I made the origianl cut file for the hinge...
If I am using an 1/8" bit for the carve, but use a 1/4" tool for the probe, which dimension should I enter into the probe function for the...
Thank you for your help, I finally found the screw that was preventing me from adjusting the machine into square.
Thanks for sending the tramming guide. Do you have any recomendations for how I should be measuring squareness? I believe my Z uprights are not...
Good morning, I am trying to adjust the tramming of my LEAD 1515 but have found no answers other than "adjust" without any details on where to...
I am having some troubles with the CNC machine also not carving at different depts. I have leveled the bed before, but is there a test I can do to...
Would the innacuracy of using an endmill for your X and Y zeroing be the cause of this misalignment? (This mis-alignment is .015" off if it helps...
The primary issue I have ran into is the pockets being carved do not line up with where I have drawn them in VCarve, however I have already...
