Separate names with a comma.
Some features disabled for guests. Register Today.
Short answer is yes. I don't use grbl so I'm not familiar with its quirks. Typically to continue a job where it left off I would rehome, copy and...
@LarsTveito is using one of these boards. https://openbuilds.com/threads/ox-stainless-with-ballscrews.8827/#post-63568 Check his thread to verify...
Since the arduino is a usb device then you are right...you will not be able to use it with the LPT. Here is a discussion about this topic....
There are a number of iterations of those. Which do you have?
Nice table!
Is this the board? Geekcreit® 5 Axis CNC Breakout Interface Board For Stepper Driver Mach3 With US - US$7.18 - Banggood Mobile
Do you have the interface board plugged in to the 24v supply too? You want to get the machine jogging around first before you throw any code at it...
Hi Jack. Welcome. Are you able to jog the machine around? Is your gcode less than 500 lines? Are there drivers associated with that usb to lpt...
Can you counterweight it?
What do you mean by run properly? The torque differences I've seen between 6.8 and 3 have been negligible to a router build. Same for the...
Or a wooden board until they can mill a case.
Welcome to the forums. Is this going to be a moving bed build?
I think this is go is going to depend on screw pitch, motor size, and torque curve data Gary.
I was gonna go there too. Went to bed instead. :) Here's another good one: AMPS Phase vs. AMPS Peak | Lin Engineering
Take 2/3's the total stepper current to determine minimum PS capacity. You only need a 3A supply if set to 1.5A for three motors. 1 phase is...
Hello Dennis, Electronics and software are usually the confusing part. Electronics can vary a little depending on the control software, but it's...
Cool.
I wasn't talking about your AC colors. I said the DC colors were wrong. All of the DC positives coming off the supplies were white instead of red....
Printer homing sequence should be xy then z. The trick there is for the operator to make sure they don't leave the hotend near the bed after...
You shouldn't have to ground the DC fan. Your colors are flipflopped off the 24v supply. Use red and black for DC just like an auto.
