Separate names with a comma.
Some features disabled for guests. Register Today.
Please can you confirm that, when you jog; X +ve moves the tool to the right, Y +ve moves the tool to the back, Z +ve moves the tool up, You...
This is the g-code produced by my post processor for Fusion and the Duet - I can see no difference between your version and mine apart from I have...
Highly unlikely that it is a problem with Fusion - that post processor dates from 2019 and has been working fine for hundreds/thousands of users....
M8 is not a valid RepRap code - if the Duet firmware did encounter the M8 command it would look for a macro with that name. There is no M8 in the...
This is the first time I've seen any mention of a "Duet upgrade". Do you mean the firmware? If so that is likely your problem - you most likely...
No, as @Giarc said, you can have up to 10 files being editable at any one time. All your other files will be read only, meaning you can extract...
Hmm, going back to Peters' point about spindle commands I do see that the file Ooznest gave you DOES have spindle commands, so do use the correct...
It's the other way round with the Duet firmware version Mark is using Peter - if the Duet sees a spindle g-code it will look for a definition of...
Hi @Daniel Smith, in reply to your private message, I started to reply to this post but go interrupted but @Peter Van Der Walt has given you the...
That is a problem with Ooznest's adoption of the RepRap V3.3 firmware (which expects an output pin to be defined for spindle control) and the fact...
Have to agree with @Peter Van Der Walt - as I said above, there is nothing in the header of your g-code that could cause a disconnection. I did...
Yes, several other posts in the list of recent posts. Post Processor Fusion 360 Alex.
Thanks David. Haven't had time yet to look at post processors for the Duet, I don't think "power" is used as a variable in any of my post...
Are you getting any error messages when post processing in Fusion, and what post processor are you using for the Duet. Fusion have made some...
What are the measurements (diameter of thye body) of your router? Alex.
Why are you using a *.TAP post processor? I very much doubt that it will be compatible with grbl. What controller set up do you have? Alex.
David has posted the link in the message above. Alex.
See @David the swarfer's response in this post ;- Problem With Post Processing in Fusion 360 Alex.
You have to set the wcs zero (set XYZ zero) in the same place on your workpiece as you set the origin in your cam software. You also need to home...
Can't help much with where that errant g-code came from, neither programme should produce that, but I do recommend learning Fusion cam -...
