Separate names with a comma.
Some features disabled for guests. Register Today.
No worries :) Easy enough to sort out with sight of your file, but ran out of time yesterday. The 2D contour path can be quite confusing as it...
What you're asking for makes sense, but there aren't any tool paths in that file - can you attach the version including the toolpaths/operations...
Autodesk changed the way that they specify the heights fairly recently that may be causing confusion - this video goes through it: [MEDIA]...
I wrote a macro for Control that will generate the G-code for power / speed array test if it is of any use: Getting started with Javascript...
I just realised that you've had a go at setting something up: i) Use 3D Adaptive Clearing to rough out, not 2D - this will need to extend below...
OK, so this is the component: [ATTACH] To perhaps state the obvious: I don't consider the ball-end mill as a stock removal tool, so the part...
On my phone at the moment, so can’t open your file. I’ll have a proper look tomorrow. In the meantime, if you skip through this video of...
Cooling rate doesn't affect the hardness of copper - quench it or not, it will still be soft. The only way to harden it is to cold work it:...
The only thing that springs to my mind is that the power supply voltage is dropping when the machine is moving - maybe something to check?
This macro should do it (unless I have misunderstood your requirements. Getting started with Javascript Macros in CONTROL / Library of Macros...
Not “everything” is specified from the ‘probing position’ (actually the origin of the WCS specified - usually G54). G53 is specifically referenced...
Definitely try microstepping (8x) and change your steps/mm to suit. Also, you could try gradually increasing your acceleration settings ($120...
I only meant something over about 30 mins This is the type of converter I used: LM2596 DC-DC Switching Adjustable Step Down Voltage Regulator...
I also use one to power my laser, however it overheats and shuts down on long jobs unless it has an additional heat sink. The only way to reset it...
That sounds like it is a brushed motor. If so, it's not suitable for a VFD.
Homing is separate from getting the axis directions right. You can set it to home where you like, but you need to get the axes going in the...
Just as well! :D I'm not sure if this is still required, but I finally got around to it in V2.1 Getting started with Javascript Macros in...
Now done (V2.3) - thanks again. Getting started with Javascript Macros in CONTROL / Library of Macros created by the community
That's exactly what I wrote this one for: Getting started with Javascript Macros in CONTROL / Library of Macros created by the community I use...
This post may be useful to you: Re: Exporting CL Data for Grbl - PTC Community
