Separate names with a comma.
Some features disabled for guests. Register Today.
Ahh - apologies. Going by the error message, I concur with Peter that the switch is shorting something out.
Erm... In the video, the axis that moves first is the X axis of the machine. The axis that you trigger the limit switch for with your finger is...
As Alex says, plus disable hard limits until everything else is working (homing, etc.). (I would advise not using hard limits full stop - soft...
You might need to install limits on all 3 axes so that the machine will home correctly (you only need one switch per axis). Then enable soft...
No, I meant when the machine only moves 5mm - If you try and home it without one of the axes connected (and haven't set it up for that), it will...
Are you trying to home the machine?
You can have multiple 'spindles', but you must use separate i/o pins for each one: Spindles It's a while since I've delved into FluidNC, and...
Not quite sure what you're asking - Do you want to engrave the outline of a 3D object into your spoil board? (You can do that by: Create a new...
The cutting forces in conventional milling tend to push the machine back against the direction of travel. Any backlash or play tends to get taken...
Probably not. The overhung weight of the Z axis will force the X axis wheels against one side of the V grooves. If the force from the cutter acts...
There could be many reasons (mainly that wood isn't a uniform material - grain lines, variations in hardness, etc.) but in this case, it could be...
Use the link in @David the swarfer 's sig: docs:software:fusion360 [OpenBuilds Documentation]
Sadly the sensors aren't suitable then - they aren't capable of pulling the voltage low enough to work with the logic levels of the Arduino. This...
Do you have a multimeter? If so, check the voltage between pin9 and GND on the Arduino with the proximity sensor hooked up and triggered/not...
Hmm. I was wondering if I could find out what type of output circuit they had, but there isn't sufficient information. ('Open Collector' NPN...
Do you have a link to the ones you bought?
Ha ha! That was easier than I thought - I didn't really need the file: [ATTACH] You have the simulation running backwards! :D You see the dot...
The screen shots are too low resolution to be able to read. Can you post the F360 file (*.f3d) and I will take a look.
This video shows the process of selecting the origin for your machining operations (WCS origin) [MEDIA] Remember you will need to regenerate any...
The SIM will usually look ok, because it is using the origin you have programmed. The problem comes when you set the machine to a different origin...
