Separate names with a comma.
Some features disabled for guests. Register Today.
I am running a spindle router on my home built CNC powered by a blackbox. In VCarve, when you select a tool for a job it has as one of its...
That appears to be the case in one of the wires. There is some continuity but it fluctuates which indicates a problem. I replaced the wire and...
I was doing some wire management today (bundling and re-routing some wires) and when I turned on my machine and started the homing cycle, the...
On my new build I have an issue that I am trying to troubleshoot/fix. My new machine has 2600mm of travel in the y-axis. When I manually move the...
Peter, I have my own home-built machine (5'x 10') powered by openbuild parts (motors, blackbox, etc) plus the workbee 1510. Right now the larger...
Are there any problems integrating the subject motor into an Openbuilds blackbox or the motor at this URL:...
Turns out the piece of aluminum plate that I was using had a slight bow in it - enough to cause the problem. I set Z-zero at the high spot and...
Here are the first few lines of the gcode for the job - I can see no problem with them especially the first Z axis coordinate where the cut...
I was about to cutout some parts in aluminum. I homed the machine, then did a probe. I set the 1/4 in. bit for a max of .0625 in. pass depth and...
I have played with the settings and have almost established a fully functional machine (which may need a bit more tweaking). The one glaring issue...
File attached.
Neither. What do you suggest I do next?
Peter, Thanks for that excellent lesson and calculation. I entered the 24.24 value into the settings saved and reset. Then I went to the wizard...
The motors are openbuilds 1.8 degree, the pulley has 22 teeth, the microstepping is ? (where is that value), the belt is 3GT (POWGE Arc HTD 3M...
I have toyed with the settings but I need to approach the problem from first principles. In the attached photo, the bottom-Left corner is where...
I have just completed the build of a new 54" x 120" machine using fabricated parts and openbuilds motors, blackbox, etc. Travel in the X and Z...
Is the Y2 motor wired the same as the y1 (or Y) motor, or is the wiring reversed?
Is there a way to save the original parameters for my 1510 and then connect to the new machine and save them also as a different file?
I have two cnc machines, one operational and one under construction. Is there a way to connect to my new build and enter different parameters...
I have enclosed 3 photos that show my new Z-axis build. I am at the stage where I am mounting the sensors. This build is based on my Workbee 1510...
