Separate names with a comma.
Some features disabled for guests. Register Today.
I am currently building a new 4x8 CNC Router based in-part on the workbee components (up-gunned) less the structure. I am at the stage of tuning...
Can anyone recommend a spindle router, air or water cooled, in the 3-4 kw range and where to purchase one?
Are the mikita and Dewalt routers interchangeable for the workbee 1510 - do they use the same clamp system?
I always register my work in the same position using a right angle fixture as my guide for placing a part. Once I find the X0Y0 position of that...
As follow-on question. Say I use a 1/4" rod for finding the centre. Then I replace the rod with a bit that has a slightly smaller diameter. Will...
Learning something new every day. I put a 3 flute bit into the router and re-ran the job. That is fixing up the error. Did you purchase your brass...
I was using a single flute cutter on a project cutting some countersinks for screw heads in Aluminum. I had previously drilled pilot holes in the...
Done, Thanks Gary. Rick
Thanks, I will try the spot drilling. Should I lower the rpm on the router? Any particular bit recommendations? Rick
I need to drill a number (40-50) of 1/8 inch holes in various aluminum parts ranging to 3/4 inch. What is the best bit and bit parameters for that...
I am using 6061aluminum. I have a workbee 1510 with a 1/4" router. I am using it to fabricate the parts using a 3 flute carbide upcut bit....
I am in the process of building a new large format CNC. I have use plywood to model all the parts for position, size, cutouts, drilling, etc. I am...
I am building a new 5' x 9' CNC machine from scratch. For the y-axis transmission, I am going to use a 15 or 20 mm belt plus the appropriate...
[IMG]
I don't have the sensors yet but I can get a diagram. This is a description of the sensor: LJ12A3-4-Z/BX New Inductive Proximity Sensor Detection...
Can I wire a 3-wire proximity limit switch into a blackbox controller? If I can, is there a wiring diagram?
By setting those variables, does that mean that the machine will home on those values. I changed the variables, and I thought the machine would...
I dropped my tabletop a few inches and changed my spoil board.on my 1510 openbuild. I need to re-establish the XYZ machine limits for homing...
Thanks to everyone. It worked the fourth time and I got the results I was expecting. I need to do some fine tuning of the project and other things...
Ok, We have ruled out the obvious problems. I wil give it another try this morning to see if it works any differently. My plan is to calibrate the...
