Separate names with a comma.
Some features disabled for guests. Register Today.
Sorry, please find attached.
Here is the full file.
I set Z=0 at the top of the work piece so that G0Z0.2000 puts the bit at .2"above the work surface - is that not correct? I am referencing the top...
Regarding the set zero response. I set the origin of the work at the bottom left corner of the blank (x=0, y=0, z=0) all three times - that was...
When I transferred my tool path from Vcarve to do a photo using the openbuilds software I was expecting a carved photo might appear on the blank...
Thanks, That will do the trick. I have placed an order.
I have had a look at the three websites that were suggested and the number of belts and pulleys/idlers is overwhelming. Therefore, is there...
OK, I had a look at the GT3 line. If I am on the correct page, metaphorically speaking, the 3mm x 15mm wide belt would be the better choice along...
Can you elaborate on this statement: I would suggest a 12 to 15mm wide belt with a 3 or 5mm module. Can you point me to a source where I can...
I have looked at rack and pinion but not seriously. However, I have not ruled it out and will have a look tomorrow. It does fit in with some of...
I decided to build a larger format CNC. I have completed the torsion box for the bottom which is approx 52x120 in. I am awaiting some parts to...
OK, Thanks.
Has anyone tried a chain drive for the y-axis and if so what are your opinions (versus 2 NEMA step drives)?
Is there enough juice in the blackbox to drive a single NEMA 34 step driver (plus drivers for the x and Z axis (NEMA 23)?
I have re-calibrate the x and y axis and I believe that I have achieved an acceptable circle.Is there a way of increasing the height of the...
I did a complete overhaul of the machine. Locktite added to the critical parts. Ran a new circles test and they came out much better - except this...
I am on to complete overhaul of the machine today. I will apply all of the suggestions and see if I can correct the issues. I will report back -...
I conducted the suggested test and it did not make any noticeable improvement. I then replaced the allen screws on the Y-axis and that improved...
Thank's Rob, I will carry out that test this morning and provide some feedback. My workbee 1510 came with 5mm belts. I was looking at upgrading to...
I have checked all the parts for tightness and stability, replaced the allen screws on the x axis motors (perhaps I should do the same for the Y...
