Separate names with a comma.
Some features disabled for guests. Register Today.
I checked the allen screws and they were tight. So I drew 3 concentric circles and ran the CNC again. The attached photo shows the results. The...
I do use Vectric. In the two pictures above look closely at the upper left quadrant and you will see the issue.
[ATTACH] [ATTACH] [ATTACH]
My open build CNC router has had a problem with circles since I built it. When cutting a circular part, at about the 190 degree position, the...
Alex, I presume the macros will work the same with the blackbox controller? Where are the actual macros to be found?
Hi Alex, I still have about 1-2 mm slop when machining aluminum circles. I will continue to refine my tuneup. On wood, the circles are within...
Hi Alex, I just finished doing a complete check of all wiring, and the test you mentioned above. I also carried out a number of additional tests...
My Workbee is a X-Y belt driven model and Z-axis lead screw. I will check all three drive pulleys for tightness. I have already calibrated the...
[ATTACH] Alex, Here is the photo of my cut of the circle. I watched the machine do a dry cut first and without any load on the system (air cut) I...
Thanks Alex, I did a complete check of my Workbee 1510 system including roller tension, belt tension, and router bracket stability. The problem...
I have tried to cut a number of circles on different material but they all seem to come out less than perfect. The two sides in the X-direction...
I have the blackbox processor. I checked the post processor list and it has grbl (in) and Grbl (mm) so I will give those a try.
In Vectric Cut2D pro there is an option to select the post processor. Which one should be selected for an Workbee 1510?
Yes I did post my comments as problem solved.
OK, thanks. I did not see the extra spacers at first view. I have flip my support rails as suggested and the limit switch. Did my first job -...
Here are some photos of the z-axis gantry as requested.[ATTACH] [ATTACH] [ATTACH] [ATTACH] These photos are all taken when the z-axis is at its...
I used the latest build video to set and reset the height. The router collet is set even with the bottom plate of the z-axis. I will post some...
I have an OpenBuild 1510 belt-driven that I just assembled and tested after some initial electrical problems. My issue with the Z-axis is that...
I have the blackbox controller. No strange motor sounds. I believe both belts are tensioned properly. Gantry is square. Movement along the x-axis...
Returned the wiring to original positions. Checked the direction of travel of both motors - OK. grub screws tight and on flats of shaft. Gantry...
