Separate names with a comma.
Some features disabled for guests. Register Today.
Eric, I don't think you'll get much support for running anything other than GRBL here. This is what the board supports. The GRBL control language...
Hi Eric, Can you explain a little more on what your intentions are. You control the steppers through GRBL code. Using various commands you can...
Nice build
Anyone using a fan to cool the board? Which fan and specs? How did you wire it up and not run into a current draw problem?
When trying the print the DIN clip it is really small! Did you create this in metric or standard? Thanks
Hi @Michael (Mike), any chance you (or someone else here) can point me to the pinout assignment for the ISP pins on the board. Thanks
Ok, I am getting the following error when trying to connect to board. "No supported kill alarm lock method for this version" This was after I...
Another newbie question here. After homing the working tool (router) ends up bottom left corner with Z-axis raised. I assume from my high school...
Added the capacitors and homing now works, I get no alarms while homing. That being said I'm still getting alarms if I turn on hard limits!!! No...
For those who have added the 0.47uF capacitor to their CNC Pro can you please post a photo or two of your configuration. Thanks
There are some suggestions I have read to introduce a 0.47uF capacitor to each limit switch line. I'm not sure how to wire this up specifically...
Yes I have hard limits turned on.
Limit switch wiring is giving me grief. The attached picture shows how I wired up my switches. However when I initiate homing it fails....
Hi Steve, do you have a picture or better yet a video of this setup? I'm trying to visualize home position (off the front of the table) and 0,0...
My OX build is up and running. I am using GRBL Panel for control software. What am unsure about is how to calibrate the GRBL settings for my...
But do you have just 3 switches, one per axis or did you put two on each axis (one at each end)?
Are you guys using more than one limit switch per axis (one on each end) or just a single switch with software limiting?
Guys is the TVS diode necessary? I'm using a 24v power supply with online 15amp fuse. If I need a diode are there any alternatives since I am...
I have one of those 24v power supplies advertised here in the parts store. On the back it has three inputs (screws) for connecting to 110v mains....
Can anyone recommend CAM software that will work on my Mac OSX machine. I'm using the CNC XPRO v2 board. Thanks
