Separate names with a comma.
Some features disabled for guests. Register Today.
Hi again and happy new year! Here are the pictures: Motor side: [ATTACH] Opposite side (the tensionner is inside the cap) [ATTACH] Overview...
Hello, I am back to close this story almost 6 month later :-). So, I have been in contact a lot with Ryan from Ooznest and spend a looooottt...
Hello, I have a Workbee 1500x1500 and I would like to convert use it for laser printing to print mdf 8mm toys. I see some cheap laser modules...
Hello, Here are the calibration tests for the z-axe. Here is the protocol I use: - Go to 0 before each measure - Go -0.01mm twice - Go +0.01mm...
I have already checked the the belt visually but I didn't have seen any troubles with it.
Hi again, [ATTACH] Here are the results of my tests. - Round 1 : the results of my previous message - Round 2: I have stretch the belt a bit...
Ok thank you I will do the test this weekend!
How could I avoid the backlash? And the tolerence of ooznest is suppose to be 0.2 so when I see a difference of 1.5mm it sound a lot to me. If I...
I just have perform another serie of tests with a maximum speed of 5000 in place of the 10000 of the previous test because I had do that for the X...
Hello, I have unmounted most of the pieces of my workbee. I have also replaces the screws of the pulley on my Y-Axe. I also use a new procedure...
No it isn't : https://d17kynu4zpq5hy.cloudfront.net/igi/ooznest/1VIfMKpFJj3wGYg4.large See the doc here about the wiring: 6. Assemble Duet Controller
I don't think that this test will be possible because they are two motors for Z and only one in X. Well I guess it could be possible by software...
Hello, I took a lot of holidays without touching this ... machine... also I have waited for someone who have more experience in woodworking to...
Hello, Here are some news 2 weeks later. I still spend a lot of time to try to fix it even if it is "only" 2-3h every two days to try to...
Well now that I think about it, my X axe is better since I have switch my motors and now my Z axe have a lower precision. So I guess that it is...
And the results with a microstep of 8: Microsteps | M92 Parameter | 5mm | 10mm | 15mm 8 | 427.475 | 4.74 | 9.8 | 15.18 8...
Hello, New week new tests. On the Z-axe this time I have notice that it wasn't correct either. Here is the protocol: I use a 6mm bit Calibrate...
I didn't had the time to work on it this weekend. I will continue tomorrow... For the moment, as you can see in the latest test I didn't have any...
Hi again, Today, I have rerun the exact same code and the result is "perfect" at least I didn't have any glitch. I have an issue on my z-zxis not...
Hi Alex, Here is a screenshot of the available post-processors. As you see I use the Grbl (mm) but they are also some G code (mm) available for...
