Separate names with a comma.
Some features disabled for guests. Register Today.
I assume that you used the Duet Web Control to upload your g code file and run it? -> Yes I do! -> Are they some other/better tools I can try for...
I have checked and yes the Post-processor is Grbl (mm) (*.gcode) and that is what they use in the ooznest videos (program and post-processor). I...
@Alex Chambers This code have been generated by Aspire. I didn't really have investigate the best cnc software for woodworking yet. I am use to...
I have found this on the duet site: Microstepping set too high. If you set microstepping too high, the processor may not be able to generate...
I guess that it should come from the duet controller...
Hello, I think I have it. Distance | Actual Cut 1 | Actual cut 2 | Actual cut 3 | Actual cut 4 100______|_100,25 _______|_100...
Good to know I will measure it tomorrow... the one I currently use is a CMT so it is suppose to be a good brand.
More adjustement and tests tomorrow ;-)
Since the motor switch are the belt check it looks a bit better finally. But first forget the measures of my two previous post because I have...
I have unmounted my belt and examine it very carefully qithout seeing anything suspicious. I have also switched the motors as proposed by Alex. I...
Hello, Here is the test results of the day... I have setup to 4 microstep and a speed of 1000 (default one was 10 000) because when I use only 1...
Ok but I don't want to cut (at least not for the long one) each time if I already see that it isn't working without cutting anything they are no...
Ok, as requested I did the two additional tests: Set the maximum speed to 500 in place of 10000 => result 10 min later I as at the origin and...
Hello, Thank you for all your reactions. @Rob Taylor : When I configure the microsteps to 8 with the following commands. I still have the issue...
Don't forget also that the same motor is used for both the Y axe and the X axe so I guess that the microstepping should be the same. Am I right?...
I will not be able to test it today anymore but I will change it the order is teh default one provided my ooznest. I was both for the same square...
Here is my config file
My cut is 4mm deep and on the X it is only 2 mm depth. The X axe give me this: 99.8mm for the 100mm and something like 405 for the 390mm [ATTACH]...
Yes that is what I mean. I have just have executed the test on the Y axe (I have recalibrate again this morning) and it is almost perfect now. the...
Btw, I have also checked the machine is mounted on a torsion box so it is very well flat and I have measure the diagonals it is squared...
