Separate names with a comma.
Some features disabled for guests. Register Today.
I want to add, when the temp in my shop is below 45 degrees F, the drive is not recognized on first boot up. I have to reboot the black box and...
Yep, that's the plan. Z shouldn't be an issue as I am 3" higher than the standard LEAD1010 now. I have a raised Waste board now that I can remove...
I understand, I'm not looking to make a CNC lathe, just something to do simple engravings on a cylinder, much like a laser cutter. So if my stock...
Saw the LEAD Lath, that might be a starting point but I'm wanting to make it much simpler and not need a second machine. Basically I want to make...
Has anyone done a rotary axes for the LEAD1010?
Thanks, just found it in the docs also.
Is it possible to add a second set of limit switches to the X and Y on the Lead1010? My theory is to tie them in parallel to the existing homing...
Haven't checked updates lately, don't always have WiFi in my shop so hopefully this was addressed. Hitting "Go to X,Y,Z, Zero" ignores CANCEL. I...
be sure to clean the with alcohol, and let dry before applying the adhesive back.
In short, Yes. If the magnet is a powerful one it can cause Eddie currents when placing and removing. I have been using a fairly strong magnet...
Already have the ER11, no complaints. Just curious. I'm considering using 2 mounts on it so mor interested in an additional spacer, but I could 3D...
Is the router 11 just a version of the Grizzly Trim router? Laminate Trim Router with Plunge Base at Grizzly.com Also, is the spacer ring...
Thanks again everyone, As for Tramming issue, I realized I drew my original image backwards, it leave the forward edge on the X+ direction and...
1. Occasionally the Interface will not recognize when the bit touches the Openbuilds XYZ probe. The Green LEDs light up but the bit keeps going....
Also note that the plastic locking connector can pull out of the Interface. I had this issue once also but it was the connector that pulled just...
Yes, the router is about center on the X beam, and I am planing on using this to flatten spalted wood logs and such, so I need about 3" to 4"....
That's what I'm going to check this weekend. I don't think they whip but I haven't checked to make sure.
@Gary I haven't ran my X into the end plat yet - I have however ran the Y into end plates, no mark on those wheels however. The Speeds I am using...
Using the Interface, it is worse at 100%. Still there even at 50% but not near as noticeable. Haven't had time to run very many test yet but I'm...
I had a little bit of time this evening, 1. I was mistaken - the jitter does happen across the entire distance of the X. It's just not as...
