Separate names with a comma.
Some features disabled for guests. Register Today.
I can't imagine my bit digging in on pink foam insulation at 0.01" deep. I think there is something else going on here, see my most previous post....
Don't know if this is related but I noticed today there is a "jitter" or "hesitation" when moving in the X positive (right) direction. It's not...
Both ends are mounted as per the instruction - didn't like the fact there was only a single mounting point at each end. A slightly larger "L"...
I'm using the mounting bracket provided with the Kit. It only allows for a single mounting screw so the chain can pivot easily on a single point,...
When moving in the X-minus direction the tool is not 90 to the table, but when moving in the X-Positive direction the tool IS 90 to the table....
How soon do you think you will have something to look at? I'll hold off ordering if there is something that might work better.
It was doing this while surfacing a piece of HDPE so I decided to recheck everything and make sure all is square and flat. The Y direction is near...
I'll give that a shot, thanks. Didn't think about the climb vs conventional, but then again I am only taking 0.01" off so didn't consider the bit...
The gantry flexes A LOT! I'm considering adding the High Z mod for the same reason - I'm hoping it will strengthen the Gantry. I am cutting HDPE...
Here is an cross section of the surface it leaves. [ATTACH]
In trying to tram my X direction I found that the X Motor is torquing the entire X C-Beam. I get a ridge (in the z- direction) on the forward cut...
After the second time my drag chain got snagged on the gantry and forced my Y out of square I decided to apply the fix I thought of after the...
Can I get this at 300mm on the Z instead of the 500?
Bummer. I'll restructure my naming convention. I see what your saying but it's so handy though ;) It would just be a further confirmation I...
.. on the Interface. Sorry if these were mentioned already, didn't look real hard. 1. Can we eliminate the "gco" extension on the USB file names?...
Before the last update, Interface boots up fast, now it checks for WiFi for almost 2 min before it decides there is no WiFi available. Any ways to...
I had the same issue yesterday. I inserted the Drive into my laptop to make sure there wasn't something wrong with the drive, all was OK. Placed...
Thanks for the quick response by the way.
Third time's a charm I guess.
I followed these instructions and now my interface is has a blank screen and all buttons lit green. except Aux, Drive, and WiFi
