Separate names with a comma.
Some features disabled for guests. Register Today.
I didn't see in Interface where I could set the Hard limits ON/OFF so I connected my laptop. In the GRBL setting both Hard and soft limits are...
humm, Don't remember doing that. But I did notice last night that my measurement units were on Inches instead of the mm that I had set them to. I...
Where can I find the patch notes for Interface? My end stops don't work when running a job with interface. Want to make sure I have the latest...
As the picture shows I am getting uneven chatter in 4 quadrants and unequal hole sizes. Not sure what to look for. Also, I can stop the chatter...
How much weight can the V wheels handle if used in the Horizontal position as in this picture? Thanks [IMG]
For anyone who is interested, I figured it out. - I was ignoring the Chip Load. My chip load was way to light. I was messing around with a 3 flute...
Posted this on another thread, but thought I would also post it here. Very informative. I've learned a lot in two weeks Who is Afraid of Tool...
Thanks for the info - I plan to do just that. I have new bits coming. As for the bit length, yes it's only about 1/16 extra. After reading the...
Found a very informative page, might help others Who is Afraid of Tool Deflection? [2020: 4 Evils + The Cures]
For the past week I have been running sample blocks trying to dial in the best setting to cut HDPE. because of some narrow cuts I have to make, I...
I guess I should ask if doing this will actually beef up the Z. Was looking at the High Z mod again and realized the router will still be hanging...
Yeah, I was hoping maybe I can get these cut to custom length, but that would include the lead screw as well. Just would like to beef up the Z is...
I want to beef up the Z on my LEAD1010, basically I want to add the second beam like the LEAD1515 has. I looked at the High Z mod, but I don't...
Just grooved on the one side. Spacers are in there. I didn't think that was normal either, but not sure how it happened. I didn't find anything...
Thanks Giarc, I spaced out I could use a 4mm bit for this. I'll have to see if I can find some 4mm cutters. I am noticing some deflection at the...
I plan to give that a shot, but it just doesn't make sense. I cut about 10 of these test puck, perfectly. Mow suddenly I have a vibration.
Wish I could, but I need a 3/16 cut. There is a inner ring and an outer ring, I'm trying to get them out of one piece of stock. The puck is just a...
Can ambient Temperature cause this? Yesterday it was 46 in the shop, today it was 43.
I can slightly twist the entire C beam from pulling on the end mill bit. Figured that was normal, maybe not? Don't see anything loose. Wheels are...
Its the same for all 3 pucks, the chips extract fairly well but do pile in the last quarter. I have a loud chatter now, where I didn't have before...
