Separate names with a comma.
Some features disabled for guests. Register Today.
Same here ,was thinking where i'm gona get a box cheaply so i can put all my electronics in and found some Electrical cabinets which cost 100€ and...
Mybe the leadscrew is bent or something which could show at higher speeds but i guess that wouldnt show at exactly 2"(did you try with the other...
[MEDIA] Just watched this and think he explains slider joints quite well aswell
Fusion 360 is not that hard to learn. Watch [MEDIA] he makes lots of tutorials for it.
No it should sit a bit under so the screw holds onto the Plate ,if it was flush with the plate it could rotate it during movement becouse screw...
I think i saw a post some time ago(not too long ago but i cant seem to find it) where the holes on the plates werent in right positions ,Contact...
Buy M5x30 and cut off the 3mm dont thin there is actualy a 27mm buyable screw.
【USA Ship, No Tax】3Axis 3D CNC DQ860MA Stepper Driver,80VDC/7.8A,256 Microstep | eBay I bought a DQ540MA +425oz(3A) motors drivers from here...
Heres how openbuilds does it at 11:33min : [MEDIA]
Sounds like the leadscrew nut is rubbing against the leadscrew too much. is either too tight(if you have antibacklash one) ,the threads have...
Did you try changing your Z motor for X or Y motor and see if problem goes away?
You need to ajdust the Steps per mm: RepRapCalculator just put like this: Expected move lenght: 600 Actual move lenght: 570 Current stepps:your...
It could be a bad bearing inside making it stuck as a ball rolls araund. Take it apart and Check if the bearings run fine(put them under load...
From this seller on ebay i got my 2.2kw motor within 5 days aswell 1.5KW ER11 SPINDLE MOTOR WATER COOLED SPINDLE 80MM & 1.5KW VFD VARIABLE DRIVE...
Try watching some of these videos ,i have learned quite a lot from this guy: NYC CNC He does a lot of Fusion 360 work and i think its one of the...
no ,you dont ,you can put them direct to the leadscrews.
Dont think you can ,diameter of the Coupler between the motor and the leadscrew is 20mm which is the same as the depth of the C section ,it will...
just weighted my 2.2kw spindle to 5kg +water which is probably only 200g ,I really dont wana exchange the motor becouse i already purcheased...
Mostlikely you use wrong post process i use modified(i have removed the G92 commands so it doesnt reset my zero points) Generic BoXZY(grbl) in...
Hehe i have the 2.2kw motor aswell but i havent mounted it yet since i was suspecting the nema 23 wouldnt be able to hold it. I am hoping the high...
