Separate names with a comma.
Some features disabled for guests. Register Today.
So I did some debugging tonight, I pulled the driver off the board, and checked the jumpers. Reinstalled the driver and had the same issue. I...
Thanks guys for the suggestions, I will check them out tonight. As for being 2.54x faster. I'm not sure. It only seems to effect the X axis, If...
Hey guys. I have a C-beam machine with an arduino grbl controller. I'm using stepstick DRV8825 stepper drivers and up until last night, they...
the more I look into this, I see some issues with some movement. The table seems firm, but if I apply pressure to one side or the other, it...
Hey Guys, I'm having a problem getting my table level. I've tried my best with some digital calipers to measure the distance from the bottom of...
Had it in the title, but it's a dewalt 611. I think it does have soft start. I was under the impression the relay was just on/off. Would a...
Last night I tried to hook up a solid state relay to the spindle enable pins. When an M3 is sent the LED turns on on the ssr. I then wired up...
Last night I think I solved it. I was reading how grbl changed some pinouts in the recent version. Low and behold they swapped the Z endstop for...
I've gotten to the point on my machine where I want to add some end stops. I know I should have had them there to begin with, but I was too...
Thanks for the kind comments guys.
Not sure If you have looked into something like this yet. Pan/Tilt/Roll & Accessories You could easily mount something like a pan/tilt system to...
Not sure about the router speed, Dewalt 611, I think it was set between 4-5 on the dial. Cutting federate: 40 in/min. Maximum stepover: .11875...
Just wanted to share a quick video I made tonight of my first real project. I made a room sign for my son Nathan. 1/4" oak. 1/8" 4 flute,...
I finally got my C-Beam machine up and running. After a short while during alignment/testing, I noticed a weird noise coming from my Y axis. The...
I'm just about finished with my c-beam build. I followed along with the YouTube video. Had to pause and rewind several times. But a lot of it is...
So I just wanted to say what an amazing packaging job on my C-Beam machine that arrived today. I mean I've read reviews from others saying what...
I've been searching the threads for some info and I'm having trouble finding some good info to start with. I'm trying to figure out what...
So I contacted support again yesterday after a week had passed. I did not get a response however a little while later I did finally get a...
Not sure if I'm just being impatient, but I haven't gotten a shipping confirmation yet. I placed my order last Monday, and it still shows...
This is some great info guys! I'm a routing virgin so I have no idea what bits to use either. Is there some type of chart out there that shows...
