Separate names with a comma.
Some features disabled for guests. Register Today.
When setting the output voltage of the 24V PSU, do you set it right at 24V or give it a little nudge for expected voltage drop when under load? I...
will I have an issue switching 48V (.0375a) contacts on a relay? Would I benefit in any way pulling down to 12V or so?
Is there any documentation on the "Dual configurable onboard Relays for Plasmas, Spindles, etc” (ie; what is configurable about them, how do I go...
Ah gotcha, yeah that was a drawing I just threw together as a quick reference. Thanks for looking out!
I just looked at the X32 documentation again and am not sure which resistor you are referring to. Will you elaborate on this?
I’ll take a look at that as well, thanks for the help Peter!
It does, I was actually going to use the “tool” enable output to trigger a n mosfet in place of the spindle controller On/Off switch, if possible....
Not sure if this helps but when calibrating the 0-10V output, I noticed that it was possible to get up to ~15V at 100% drive command. Should it...
No, it does not.
Spindle disconnected, PSU disconnected, USB cable connected to computer but disconnected from control software. I get pretty much the same...
The results I posted were after an M5 had been sent. I can completely disconnect the power supply from the X32, disconnect from OB control...
Attempting to use the 0-10 VDC output signal to control my 48V spindle PWM controller. I have calibrated the 0-10 output to “10 VDC exactly" but...
Weight and torque aren’t a problem but I have been avoiding using an actual router because I use my CNC as a “desktop” unit in every sense of the...
Thanks Craig! This looks like what I need but I’m still novice enough to admit I don’t fully understand all of the specs myself. Any other...
I recently decided to upgrade to the X32 from my generic GRBL controller due to what appeared to be missed steps and general communication issues....
