Separate names with a comma.
Some features disabled for guests. Register Today.
I’ll keep an eye out for your dust boot... And might try bonding myself to the machine. Thanks for the insight
I'm not sure if this is the right spot for "this" or not... My "shop-vac" has intermittently been triggering a "hard stop"...I'll turn the...
Haha, not at all...but I am green and an idiot :-)
It's not that I can't...I'm very green with this stuff and learning as I go :-) But that makes sense, it wouldn't be too bad because I do have...
Bummer, I do like the ability to jog the machine by typing into the DRO...this is a pretty specific situation. Trying to think of a work...
I'm not in front of my machine to try this (at work) but is it possible to use "CNCnutz (Peter Passuello)" technique of zeroing off the wasteboard...
Eh, ok...not sure how or why but my steps got all wonky and my Z was moving a lot more than it was supposed to be... I think we're all sorted...
Noob question.... Can someone please explain where Z0 "is" when using the Z-Probe function? I have a Z touch plate and it is 19.3mm thick....
No, red is the permanent... I went ahead and used blue on most of the bolts.
I was too scared to drill the motor flange :-)
Hello All, Has anyone else found that the heads on the 50mm bolts used to mount the OpenBuilds branded NEMA 23 motors are too big? (the diameter...
Thanks Giarc, I figure it can’t hurt.
Hello All, I don't think this needs an entire thread but just a quick question... Should blue Loctite be used on the various bolts holding the...
Bats, I can definitely appreciate your first cnc, looks great to me...bet it taught you many valuable lessons. I’m going to keep the G540...
Quick question, should we be using “blue” Loctite on the bolts? I’ve built quite a few R.C. Helicopters and fly full-scale and have a healthy...
Hello All, Just dropping in to subscribe to this thread, say "hello" and thank you for all the info (just finished reading all 8 pages). My LEAD...
This would be so sweet for a C-Beam OX
Just placed an order with Drillman1...bits look good and his prices are the lowest I've seen....and over 19,000 positive seller feedback. Thanks...
Nice, thanks RSW...will check out Drillman1
Thank you for the replies. So far I haven't had much luck 'locally' (less than 1 hour drive). I'll have to broaden out a little. Plenty of...
