Separate names with a comma.
Some features disabled for guests. Register Today.
Nice! I’m looking forward to seeing your build. :cool:
True, but the 15’s are a little more stable IME than the 12’s - I run the latter on my 3D printers. The 15’s are more expensive, that is true.
Good choice, just make sure you get the MGN15H version.
Howdy, thank you. Yes that’s correct, I’m using 2 MGN15 carriages, but they are the larger H version. I’ve had no issues at all with play. The...
When I studied electronics many years ago, they drummed this into us pretty hard. It’s bitten me most times I’ve ignored the advice! :D
You can use any USB or Bluetooth device with buttons on it. Then you just need a free key mapping utility....
Cheers, I think I finally have the new cabinet design nailed down. High voltage cabling will run to the right, and low voltage to the left....
My CNC machine making something for a change! [MEDIA]
There’s now a Printer that might meet your requirements. [MEDIA]
You can buy a DLC32 board for $24 AUD or 13£ that runs grblHAL, and supports an external wifi antenna and works with external Stepper motor...
If you have a good mesh Wifi system, I don’t see any reason not to use Wifi, if Ethernet is not an option. I’ve found that with a decent off the...
Howdy, YouTube comments are rather temperamental ATM so I’ll reply here: i could never get wifi working on the stock firmware, I had to use...
The basic onboard spindle relay should work just fine, but the PWM output (5v) Is even better as you can control power levels. I’m now running...
I plugged in a USB joypad, I had lying around, and mapped the OB Control jog keys to the buttons.
Same here, however the board itself is still the best affordable 32 bit CNC board on the market IMO. Nothing else comes close to its flexibility....
Unfortunately it’s useless on everything but the stock firmware. TBH I think it’s kinda useless anyway. I got so annoyed with its limitations that...
@MikeP here is my grblHAL config and how I flash the DLC32 v2.x. The flashing process applies to the stock FW too as the process is identical....
Howdy, I’m using grblHAL on mine, but I’d be happy to upload my fully compiled firmware to GitHub along with instructions for you if that helps?...
I haven't made any major changes to my CNC machine lately, although I do have a small pile of external stepper motor drivers and a proper 36v Mean...
GRBL_SPD v4 is about to be released and I was lucky enough to get one for testing. :cool: Introducing GRBL_SPD v4 [MEDIA]
