Separate names with a comma.
Some features disabled for guests. Register Today.
If you want to use arduino to control the vfd. You can do what I did. I used this:...
So. After some digging. It is a wire. The white RX connection at the interface. Seems the tab that holds the wire on the connector wasn’t there...
Hello, I was using the interface with no real problem till today. When I move the interface, I get a disconnected warning on the screen and...
Drawer part built. Rails mounted. Now to attach to bottom of torsion box. Enough room for all tools, hold downs, etc in one location. [ATTACH]
New ball screw showed up today. Changing from the 1604’s to 1610’s. At the same time, adding some new parts to the machine. Linear rail brackets...
Simple pull out drawer to be mounted under the machine to hold the tools needed. Spots for all collets, and router bits. Collets ranging from...
Is it binding or is it the stepper is loosing steps? If you slow down your feeds, does it not bind? I’d run a job with the system in open air...
Started making side shields and tops tonight. Cut the left side, and started bolting it together. Cutting the side shields as one piece, 1524mm,...
I also have a 1515. The stock axis dimensions are only 1170 X x 1250mm Y. If you put a spoiler in that cover the entire opening, you will have an...
I had the same problem with dc/earth ground. And found it to be the USB cable connecting DC- to earth at the computer. I added a small devices to...
Your right! It was go to zero. Can it be changed to do X/Y prior to Z? Or move z to say 25 prior?
well. That’s weird then. The Z ends at 20.5mm when done with a job, which clears the jig. The homing dropped the z to 5 then started the move....
I had a slight mishap last night. I was putting the interface back on the shelf below my machine and hit the homing button. Normally wouldn’t be...
Wanted to recreate the board game with some improvements. This is the 1st attempt at it, and I will be recreating it with multi color acrylic. I...
Ok. Let’s try a big file with the interface. Still uploading then I’ll run it. [ATTACH]
“But, these little set-backs are just what we need to take a giant step forward. Needless to say, I was a little despondent about the melt down,...
it’s going against the C-beam. To bevel the c-beam, I would have to disassemble the Y/A/X. I’ll look at that in the morning. It’s too late. And...
Well. ****. Was starting the aluminum tonight for the side panels. I was going to put a angle on top, 1/4x2, milled to cover the top of the...
Quick update. Where I was getting .6-.8mm prior to the supports, now it’s about .15-.2 after. So much better. Once I change the Z axis, I’ll...
Hello, There is the option in the interface to turn the spindle on/off.. I use a water cooled spindle that uses the M8/9 to control the...
