Separate names with a comma.
Some features disabled for guests. Register Today.
I'm Based in the uk and the plate was purchased from a uk company that turns out to be based in Germany, It come via UPS very well packed, they...
I run the 1m actuator, The anti backlash nut does reduce the whip, with my rebuild I am using a standard nut and the anti backlash nut, hopefully...
I have run a v-slot bed for a year on my c-beam, while it worked well the lack of clamping depth started to be a problem, I have moved over to a...
sorry that was a pebkac, I meant single end single ended vs differential There are many articles on google some very technical Single-Ended vs...
You say the X axis motor is getting hot is the carriage binding up ? What machine is it ? OX ? what power supply are you using ?
All the info you need is above to wire the motor and encoder to the driver then its just a case of 4 wires to connect it to your controller of...
I made the same mistake with my c beam - I like a bit overhead to allow for the unexpected, Its never good to run things on the edge as there just...
what's the exact model number off the back of the stepper motors ? OB motors are Chinese as are 90% of the lower end motors ;) not all motors are...
A bit more digging, I found that Techno changed servo/motor suppliers, I have found the specs for those encoders used with the LC controller...
Pin outs for the encoder 2 A 3 B 4 I or Z 5 +5V Encoder 10 A 11 B 12 I or Z 13 Encoder GND I doubt the encoder is a HS35 as its too new...
a flyer for the lathe Metal LatheDAVinci That lathe uses the LC controller board, it also shows you the stepper motors Techno CNC Router...
Does the control board that's in there not work ? or do you want to upgrade it ? The servos are 18-24v brushed, and you have a vfd for the...
The encoder should either have 2 or 3 output pairs, 5v + and a encoder ground - are there 2 cables going into the plug ? if so one will be the...
I'm not familiar with that type of servo, can you pull the back off the servo and see if there is a part number on the encoder ? ac or dc motor ?...
There are all types of members on here, Openbuilds is a lot of diy machines built on a open source platform like most they start it has hobby and...
your on the limit with the xpro with those motors without heat sinks and fans Taking a second look at those stepper motors they are not great,...
I have always run my c-beam machines without limit switches, I am currently rebuilding my double wide with limit switches in a NC configuration so...
lol at this thread, yes her channel is aimed at a male geek audience as they say *** sells and the people behind the scenes know this Back on...
A little bit of chaos, wiring is 75% done, soldered, heat shrink, convoluted tube, a bit of tape and more heat shrink - I'm going to redo the...
[img] [img] [img] [img]
