Separate names with a comma.
Some features disabled for guests. Register Today.
clamping the parts together helps, put the screws in loose, tighten up the upright one then the bottom one I have just rebuilt mine as I wasn't...
what cast corners do you have some are flat others have locating tabs these are fine when lining 2 channels that run the same direction but if you...
not sure what you mean, z is up-down x is left-right y is in - out so what you're saying is. 1. A fixed build plate on a Y axis, and the Z...
looks good, my only concerns would be with the uprights not being strong enough - maybe box section to a similar size as the L section and a...
I drilled and tapped the holes out no issue - I have a small workshop what I have kitted out over the last 10 years most thing are not a issue - I...
charliex I like that idea it should take out any flex in the build plate, I was toying with using 2 Y axis C beam actuator
There dead on your blog, looks like there set to private ??
openscam is brilliant for simulating .cnc files Its been a steep learning curve but I got my first 2 cuts done yesterday - next up is a multi...
Your only doing the very end and your not taking much more than 0.1mm off the thread - if you do it in stages you can get a very tight engineering...
I have been doing vinyl for 10 plus years - surecutsalot is a nice little program 99% of vinyl cutting is vector based so anything that does...
You just need to flat off the tops of the thread by sticking it in a drill and holding some emery/abrasive to the end as per the v-slot actuator...
I have had 2 versions of the code sender 1 worked the other didn't, the one in the software download didn't work for me The one on GitHub does...
try the universalGcodeSender java app, I've had no issues at all with it, I'm just getting to grips with fusion360 what is free to the hobbyist
What amp/voltage psu are you running ? what spec are the steppers ?
iirc the drawings are with the download for the c-beam also look under the resources tab at the top of the page...
there are trim pots on the xpro what can bee seen here, http://openbuilds.org/builds/cnc-xpro-driver.643/ about half way down the page
have you tested the motor off the c-beam as your lead screw may be binding up, have you checked the grbl settings and/or setup the interface...
@Jonatan Rullman Just had the exact same issue in my case I had to make 5.40mm spacers to take out the deflection if you would like to message me...
Hi all new to the forum and cnc Just a few thoughts and issues with the C-beam kit/bundle This kit was purchased from a uk supplier - what I...
