Separate names with a comma.
Some features disabled for guests. Register Today.
yeah, but it's worse with PET-G, on my delta printer, when I printed the C-Bot bits, the probe detection height changed a little bit, so it...
Here is the link to the swiss clips for the E3D heated bed, have to select the button that says "swiss clips only". You may also want to look into...
I have noticed the heated bed bouncing on my c-bot and Chris Roadfeldt's live streams on youtube, but it doesn't cause any visible z-artifacts...
The issue with smoothieware and Simplify3D is a problem with both programs. As far as i know, it only happens with very high resolution models,...
I personally play with 123d design, Fusion 360, and OnShape (cloud-based browser CAD), but I am far from an expert... barely qualify as a novice...
I do have a large chunk of Mic-6 aluminum that is almost large enough (short by r=3/8) to inscribe my heated be into, but it's a 14 3/8'' diameter...
Yeah, I would buy from McMaster, but they offer 8x8 and 12x12, not 8x12, and I cannot cut it myself reliably, and I don't know of any machine...
0.25" Cast Tool & Jig - MIC-6 Aluminum Plate - Buymetal.com Midwest Steel and Aluminum | Buy Metal Online | Online Metal Supplier this place has...
Yeah, I found some that insta-quoted $29 for 8x12'', but when I entered 8.4x12.4'' it quoted $60
Yeah, the bit in the documentation about the borosilicate glass is a somewhat new adition I think, it wasn't there the last time I had read the...
I just got my PrintBite in, and the directions recommend not sticking it to borosilicate, they recommend mirror glass, I would stick it to...
Does anyone here use PrintBite? If so, has anyone had problems with it on borosilicate glass?
it sounds like your firmware isn't set to use the corexy calculation setting, it defaults to normal cartesian, which makes these move at 45...
if you want a smoothie compatible board with swappable drivers, look into the azteeg x5 mini v3, available at panucatt and ultibots, but it only...
Could always make the forum publicly available to celebrate hitting 100 pages!
I can personally vouch for zebra plates, i like it a lot, PLA doesn't need heated bed on it unless it has a small contact area, i haven't tried...
a while back in this someone mentioned running a belt between 2 motors wired to the same stepper, couldn't you use a similar set up with 3 screws...
The cut guide is for the hole-to-hole distances of the build plate It has been recommended that for larger than 12sqin platforms 3 leadscrews be...
what kind of dimensional accuracies are required for the printed parts?
