Separate names with a comma.
Some features disabled for guests. Register Today.
I would love to adhere to the standards! So right and back means the far right corner as I face the machine . Also the limit switch on the y axis...
Many Thanks. It sounds like it all begins with getting the limit switches wired in ( at least the easiest path). I will start there and update...
Ok, I know we have a a coil of control wire. I don't know that it came with the limit switches but if its 3 wire I should be good to go. So once...
Gotcha! So I am heading over to the makerspace where the machine is shortly. If I remove the "reference Rail" on the y and then select the...
Alex and Peter, Great replies! Thank you so much for such concise, on point feedback. I feel like I am almost there, so let me clarify a few...
Hey Folks, I know this is going to be one of those questions where I feel stupid right after someone explains it, but here we go. I just expanded...
I guess I can try it and then step up the the High Z if I get to much deflection. When I look at pictures of the high Z it looks like the first...
So my cutting is a couple of pieces of 20/80 that I need to trim down from 500 mm. I am trying to up my z height without going all the way up to...
Thank you sir. Clamped and slow is on the plan!
Very helpful. Thanks for sharing your experience. I only have a couple of cuts so I am thinking I should be good to go.!
Thanks for the clarification. Sounds a bit scarier than I would have imagined. If I break the saw it would have been cheaper to go with a...
Thanks for your reply ! It seems like the worst case would be dulling the saw blade and I never noticed any impact once the T- Trac was cut....
Hello, I have two 500 mm pieces of extrusion that I need to cut ASAP. I have used a wood blade ( Whatever is on the saw) to cut individual pieces...
Thanks for sharing, that is helpful! Now my curiosity is up and I am going to have to check out my "Ferrite Core". Will report back my findings!
Yes BlackBox . I guess we had the Dewalt set up wrong and just did not know it. Not sure about the device on the Makita power cord. It looks like...
So We have been running a LEAD 1010 for a good while. Recently our Dewalt router kept dying. We replaced the brushed 2 or 3 times and would get a...
oops, this was quite helpful. Just realized I never said Thanks.... So many Thanks!
Thanks. I was using Openbuilds control and I had imported the gcode from Easel. So when I see the gcode stream across the view window in controls...
So I am still chasing intermittent issues with my Lead 1010. I was about 1/3 of the way thru a job and the gantry just stopped moving. I paused...
Thanks for the link, that is spot on. We use a small token to access the building. I am pretty sure it is RFID, not sure who makes the system, but...
