Separate names with a comma.
Some features disabled for guests. Register Today.
Perfect, thanks for the info and great job on the root cause determination! :)
So moral of the story is to ensure the stepper is not touching anything other than the required srews for mounting? E.g.: not resting in a tray,...
Interesting, have some questions if you don't mind. :) What stl files did you use for the hot end carriage? What plastic is the carriage printed...
You might have done this already. But can you flip the bed over and try the counter sink again?
+1 - Having experienced Auto Supports leaving things hanging.... +1 - Really like it regardless. :)
New generator will be up this week. Added the following relative to the C-Bot. * E3D Titan Direct Drive. * 360 degree fan duct. Automatically...
The bouncing you see in the stream is the entire printer moving slightly due to the inertia of the XY crossbar. The camera is completely separate...
openSCAD is in a class of it's own. - It's my go to choice most often. My generator is built exclusively in it. For the larger format printer I...
I bought a 12" MIC6 from McMaster and then drilled and counter sunk the holes myself using a drill press at the high school. Helps to be a mentor...
Yeah they I've run into the docs changing midstream before myself. :) As for aluminum beds, I run a 6mm bed, technically it's ΒΌ inch, but close...
Quote from http://mutley3d.com/gallery/printbite instructions.pdf Application to normal 2mm window glass is not advised. Borosilicate glass is...
I assume you are using Marlin on RAMPS/Mega? If so, have you set the voltages on your stepper drivers? What version of Marlin are you using?
Nothing that I am printing at the moment. I am going to start doing some polycarb and nylon prints. Some of those filaments get into the 270deg C...
duh-oh, added it to my original post. :)
Anyone done the PT100 conversion on their E3D hot ends yet? V6 PT100 Total Upgrade Kit
Yep soldering is involved. If you go back several pages, you'll see where this discussion has come up a few times actually.
I can vouch for going the mosfet route with a beefy heatsink and a fan. It works great and wasn't much more expensive than the cheap SSRs.
I would just add one more and that being Problems & Issues - Redudant I know... The fewer the better. My two cents, we really needed the ability...
K, hell has frozen over and I am switching to direct drive, I think.... To those of you with the titan extruder, asking for your thoughts on it....
Measure your filament at 3-4 places on the spool at least. Check both linearly up and down the roll and also axially around the same linear...
