Separate names with a comma.
Some features disabled for guests. Register Today.
Yes, it depends on the tolerance of each nut but I find that it works more often than not. I've been using them as drop-ins on my build and in...
A good alternative to plastic nut holders is square nuts, they fit in the Vslot and they are just narrow enough to be inserted into the face of...
[IMG] The two lower holes on each xy idler piece and the print carriage have slots with slanted faces to allow the wheel axel bolts to move up...
Do you have the belts installed and tightened? The xy beam should move by hand with some resistance if the belts are on and tightened. If belts...
For anyone who has been waiting to pull the trigger on ordering parts for a cbot or looking to build another one, there is a sale on openbuilds...
Here is a video demonstration of a C-bot running. [MEDIA]
Craftware is a new free program i've been slicing with, you can add custom support material as needed
I haven't seen anything similar in my Cbot. My bot has the Z bed lifted by two centered screws and all of my belts are pretty darn tight. I'm also...
Could you provide a link to those endstop switches? I like the smaller form factor.
@AK Eric built the biggest version of this printer that I have seen Building the C-Bot 3D printer: Part 1
I think your message got buried earlier. I believe this is the fan duct I remixed and put on my Cbot. I'm using it with an E3D v6 and it all...
I preferred to put my X endstop on the print carriage so that the printer can always home each axis independently and it can always do the default...
This is a good resource: Marlin firmware user guide for beginners | Solid Utopia @AK Eric also has some good setup tips on his blog page Building...
These combo fan ducts seem like a bad idea, if the fan gets switched off or cycled down at all you could risk damage to the hot end or at least...
I've been following all of the new direct drive developments and the results look good so far. I can't help but think that this design somewhat...
Does this go under the flange of the push fit coupling? I noticed there is some movement there.
This is essentially what I did but I set up a lead screw on either side, takes all of the torque off of the wheel assemblies and avoids the diving...
No problem, all of the parts for my printer are posted here: D-Bot by spauda01
Does anyone feel like sharing some slicer settings regarding retraction that have worked for them? I'm trying to fix stringing during print moves...
The bundle of wires ziptied to the bowden tube help to kind of keep it in place, it still has a tendency to fall over depending where the print...