Separate names with a comma.
Some features disabled for guests. Register Today.
Hi, Peter van Der Walt i did video show how machine is performing. [MEDIA] i have not done probe test yet, or E-Stop would like no how setup...
the setup when well. The stepper Drivers DM542A Pin enable, This is enable in openbuilds setting, LCD is red, when i jog X,Y,Z The motors don't...
hi, So i enter my previous setting. I'm going run test on the stepper motor to make sure they're going the right direction. Apart from this...
openbuilds establish communication:thumbsup: don't want get too far ahead of my seft but very important question., When i was using bCNC, My...
hi, i plug in the new arduino uno board, and open openbuilds >>Click Wizards and Tools > Firmware flashing > Select your board, port and flavour...
i don't think you understand, this is first time im setup Arduino uno board and install arduino software + install openbiuld software. all i did...
by the way, This my custom build setup. work 100%. i just want to disconnect respberry Pi 4, And use my mac to control it.
But my system that i have now it respberry Pi 4 + arduino/cnc shield and running 100%, I just want to disconnect the respberry Pi 4 from...
hi, 1.) I install Arduino IDE V2.0.-rc6 and now connected to mac usb3.0 Arduino Uno on /dev/cu.wchusbserial20 i did blink test work perfect. I...
ok, would it work with the Aduino UNO R3 + CNC Shield Board Controller. Apart from installing the software is there any configuration within the...
hello, i did research on how to install bCNC software on macOS, None was clear enough explaining how to install it. Can any one help. to install...
hello, eveyone. Im new here. I hope that im in the right place for HELP?? So i recently got new CNC 6040Z unit. And it came with the JB-3163B 4...
