Separate names with a comma.
Some features disabled for guests. Register Today.
The 269oz/in stepper will be more than enough. The Z axis stepper has really not much hard work to do. Lifting the router is not a big deal and...
I would guess to put the flexible coupling, which I think is not really necessary in this build.
Corey, you are not getting much of a Z axis travel, right? Also, the Z axis stepper is quite beefy. 3nm is what I have on the Y axis and it does...
2 weeks from NJ to Atlanta??? I could make it on a bicycle in 3 days! LOL
Dimitrov, start by adding another clamp to the router, as far apart as possible. Shim the CLAMP so that you are square on the Y axis. Use longer...
Why would that be, I wonder. I got one. It was around $30 shipped from China. After I've installed it I found out it NEVER even gets lukewarm and...
Peter, I think most people hated the popup not the info. As I have suggested before, a label with the info that is constant but not popping up in...
I don't know what kind of spindle Netechsys has but some spindle are square with the mounting holes in the housing and some are a round barrel...
Do yourself a favor and use two clamps to hold the router and not one. Install them as far apart as possible.
The flattening of the spoil board is only to correct unevenness in the spoil board, it will not correct the problem of the Cbeam not being true....
Air cooled
Another option would be a petal grip, as suggested by Rick, actuated by a RC servo, something like this.
You are switching a SIGNAL not a LOAD. The amperage in this setup is so minimal you don't even have to mention it and so is the voltage (in this...
To be honest, I never was active on the Mach3 forum and never looked for a solution for this problem. I just had it, 10 years ago on the...
That's the salient point! How do you clear the alarm without moving away from the switch? As long as the switch is pressed the alarm stays and I...
I have a 1.5kw spindle, I never use it at full 100%. I always run it at about 70% but I do this for the RPMs not for the power. If I had to buy a...
Dimitar, if you are confident in your soldering skills then soldering a new switch should not be a problem and the switches are mostly very common...
LOL, the first line in the linked page says: And guess which Pi I have :mad: :mad:
I don't have the exact weight but my spindle is not heavier than the Makita clone I have, which is about the same size as the RoutER11
I was talking about spindles. Check AliExpress for '800W spindle'.
