Separate names with a comma.
Some features disabled for guests. Register Today.
I like Due/RADDS. RAMPS hardware, typically, has so many corners cut I'm surprised it isn't shipped in a circular box. Polyfuses might reset,...
There is an ongoing debate about whether the smoothie firmware behaves correctly in some conditions, specifically when Simplify3D throws...
I migrated my Kossel Clear to Due/RADDS running Repetier, and it's been smooth sailing. No more melted connectors or fried mosfets. I like the...
The combination of Repetier Host + Firmware is verra nice. The firmware by itself tends to be much cleaner, and (at least on deltas) a bit more...
Good tip... I just checked, and the volcano eruption pack (from Filastruder) I have in my "parts to assemble" box has red wires. Aha! Looks...
I don't think the accuracy of the flex3drive should be any less than a bowden setup-- In fact, it should be better, just not quite as good as...
Search for 'flex3drive'.
So it's not the best photo I've taken-- Shoulda gone F11, instead of F8, and should have dusted the thing first. I believe the red and black...
I bought a set, and they work very nicely with the delrin blocks. Now I just need to finish assembling the printer and find out if they're...
Somewhere on the openbuilds site is deflection data for the various v-slot profiles. I don't remember specifics, but 2040 should be good for...
Ah. My bridging ability on my current printer is... "decent". I get a small amount of sag. One of the reasons for building a new printer is so...
So why the hexagonal holes in the motor mounts? If you're going to stick with those, I'd rotate them 90 degrees so the "flats" aren't parallel...
The problem is patents-- 3D systems has the patent on deformable baffles for a heated enclosure. At the risk of completely honking off 3D systems...
First thing that springs to mind is the wrong steps / mm on the Z axis... Alternatively, some form of slippage. How's your Z axis built? I did a...
Whats your print surface? It's designed to reflect off of glass, but they've discovered it will go through PEI and reflect off of the tape...
I've got a 600mm bowden (on a delta)-- shouldn't be an issue. I'd check the feed rate / accel values for the extruder. I'll second the vote for...
If I recall, Buildtak is a variation of Ultem, which is PEI based. So they're pretty closely related. I want to like buildtak, but I've always...
For me personally, no-- I'm completely ignoring his leadscrew parts-- instead I'm using the openbuilds tr8 leadscrew/nut block, a NEMA-17 motor...
Oh, fine, be reasonable, take things like printing quality into account-- see if I care! ;) I take it you're doing heavy rework just as I'm...
It may be because of the angle, but in this case, I think I prefer the simple plate. The chamfer clashes with the corners of the base, which may...