Separate names with a comma.
Some features disabled for guests. Register Today.
Not sure if I should ask here or on a new thread - but I'm also unclear about the toolpath calculation accuracy, if I set it to 0.1mm does that...
Solid State Relay specs SSR-25DA Datasheet - 25A, DC to AC Solid State Relay - Fotek so it looks to me like it would operate directly from an...
well it seems to be the norm - i don't know if it causes anyone problems. My SSR is active high - ie When I send it +12v it switches the 240v on...
the relay boards I can find are all "active low" is that normal and correct? surely that means if the arduino is powered down then the relay is...
with the above breakout board; why not line up the screw terminals and the header pins and run the wires flat to the board and straight across?...
looks like we are designing a fully modular printer setup. Not what I set out to do, but maybe a better result. * I just realised that I will...
Yes, it is all quite simple in principle - I just wish there were some known good solutions for this application documented... I will look for...
If you want an easy turnkey solution with good documentation get the Xpro or some similar integrated board. The Xpro is essentially a Uno with...
The thing i'm most stuck on is the best way to make individual external boards for controlling heaters and so on. the RADDS board offers several...
I'm clear on that - Klipper needs an Rpi or other "real" computer to run the main body of code because it is written in python which is terribly...
Yes I think it can, but the default assumption is that you connect to octoprint over the network and all the documentations and easy Rpi images...
yes RADDS is a hardware system, it can be run with Marlin, Repetier, Reprap or Klipper firmware. Although I don't need the stepper driver slots on...
If you use external drivers you don't need an Xpro a regular arduino will do.
the radds.org website appears to not exist I get a 404 - doesn't bode well.
My parallel finishing toolpaths in Estlcam have a lot of unnecessary lifting the spindle out of the cut and putting it back again at the end of...
to clarify - I want something to use in the CNC machine - not in a handheld tool afterwards.
I am cutting mostly smooth curves in 3D in wood with little fine detail. Accuracy is important but the surfaces are smooth not detailed. I've...
further thoughts: * AFAICT Klipper relies on octoprint for a GUI - so that's an extra piece of software. Furthermore the default way of...
thanks. The TB6600 look like great value. Do you use them directly from an arduino with no shield board? if so that saves some money too....
OK - what sort of problems? Stepstick seemed like a big step up from the integral drivers on my existing board where if a driver blows the whole...