Separate names with a comma.
Some features disabled for guests. Register Today.
I just measured it, 17 or 18 thou (with paint on both sides). I figure I made up about 70 thou on diameter, close enough. I have FEET of this...
For Dewalt 611 users; It is a bit smaller in diameter than the Bosch Colt that the mount was designed for, the front clamp of that mount CAN be...
I am getting the idea that MeshCAM is good for "carving" use, e.g. a small ball end mill that will go in almost anywhere and get all the material...
Fun toy, but with the knees and shoulders so far forward a REALITY machine response would be to flip him over and have a 100 MPH free fall "wind"...
In an earlier reply I had meant to mention that with NEMA 17 motors I had better luck isolating them with (cheap, simple, readily available)...
I think about the two Y beams quite a lot, are you doubling the length of them as well ? and if so will you have to double the side rails as...
Well, Where I think MY head is on this is that two Y beams would just about eliminate any "SLOP" that I may have allowed to creep in. I've tried...
If I may ask ? What machine have you post processed HSMWorks to ? There is a HUGE selection, including generic grbl and generic grblplus - - but...
I know you didn't ask me, but if you read ALL the discussion thread you will see some ideas for "doubling up" in both the X and Y dimensions....
Astrosyn dampers seem to be the standard isolators on 3D printers for the NEMA 17 motors, but they are typically mounted ON plates (of melamine or...
I have no solid theory to support this, but I think most of the "ringing" is coming from the edges of the extrusions, not the enclosed...
I've been playing around a bit with the noise issue. Molten lead filling ? I didn't try that (YET). I agree that a lot of it is probably coming...
Beware the rabbit hole Alice - or in this case the quality/reliability hole. Connections (of whatever type) that fail under (non destructive) test...
An alternative is to wrap the electronics in fiberglass mesh "bug screen", NOT the aluminum type. If solder joints are "dry" or "cold" they need...
I have no idea whether these are "good cutters", but I will probably splurge on them anyway as "single use roughing tools" that will get me...
Fusion 360 seems to be incredible - complex, comprehensive, etc. I've been watching the tutorials and playing with it in "air milling" mode. Lars...
Any idea what spindle/chuck/holder this is ? [MEDIA] I don't mind hand changing tools at pauses, but as built the C-Beam machine with a router...
Their "find a distributor" page says to contact them if you are outside Canada and USA; http://www.harveytool.com/FindDistributor.aspx Might be...
I don't know if these are available in UK, but Harvey Tool seems to offer a wide array of tooling in the smaller sizes that router CNC machines...
