Separate names with a comma.
Some features disabled for guests. Register Today.
How do you use the 3-way switch with the IoT power strip?
Does the XPro V4 board has a power supply connected to 12V-24V input terminals?
What's the length of screws for spacers making the gantry plates stiffer?
Stepper motor drivers may be bad.
Did you measure your bits? Some bits are not exactly the size listed on the pack. For example, a 1/4" bit is really 0.24" instead of 0.25".
Even with the 3D View disabled, the software stopped responding a few times and I see "websocket disconnected" messages.
Is it possible for a new version of OpenBuilds Control Software that doesn't use websocket?
I don't use Fusion 360 but I use VCarve Pro. Go to Fusion 360: grbl post processor install (the easy way) and follow instructions on installing...
I'm not sure if you can lay the 20X80 beams that support wasteboard on their sides.
I don't see any wire inside the hose.
The vacuum hose is made from black flexible plastic (I think) and connected to the Shop Vac.
The third stepper motor driver went bad this morning. I had to order new one.
Where will the machine be put in the room? I suggest putting the machine in the center of the room (think kitchen island) so that you can around...
How do you suspend the router cable/cord over the machine? I suspend the vacuum hose over the machine using a spring.
Try updating the drivers for the GMA 3000 card.
It looks like ArtCAM is discontinued.
In the software that you use to create toolpaths, edit the toolpaths by selecting toolpaths not yet cut including the toolpath where the machine...
I have rebuilt the machine so that it's similar to the LEAD Machine. I think that the adapters should be made from aluminum.
In VCarve Pro, there is "Allowance Offset" in "Machine Vectors" in "2D Profile Toolpath". What is "Allowance Offset" for?
I thought that you're not supposed to run two motors off one driver.
