Separate names with a comma.
Some features disabled for guests. Register Today.
Correct, though if you undershoot on the calibration, the outside might be correct (incorrect calibration + error in endmill cancelling out) and...
If outside diameters are correct,and inner are not, it could be endmill diameter being smaller than spec (say a 6.35mm endmill ground to 6.25mm -...
Did you remember to also update your USB drives with the next gen Wifi instructions docs:interface:wifi-setup-nextgen [OpenBuilds Documentation]...
One the scale you see (1mm over 700mm) yes, not inconceivable, its not really a stretch as kind more an unroll. If it ever was a overtensioned of...
Well in that case, overtensioning can indeed elongate a screw... So it might be stretched
Theres the main problem. The maths assumed Z zero as the exit point of the V-bit. So its not meeting up as a corner because you told it that...
Interface is not for use with the computer. You use either a Computer, OR the Interface to control your BlackBox Connect USB to the Blackbox to...
Combination of the older Interface (existed long before X32 around, so not as compatible as a newer one would be, as you saw in the Documentation...
Ours are spot on, so its not that then Loose setscrews on shaft couplers?
Just get ours. Specially made with perfect electrical specs. Those you posted have very Inductance, will run about half as slow as ours before...
Please take a screenshot of the CONTROL window on Serial Terminal and on Troubleshooting tab for us to review thanks
Control which device is powered on: laser powered on, spindle powered off for laser jobs, and other way round, laser off, spindle on, for routing...
Do double check all terminals. Slightly loose terminals is a sure fire way to lose a Blackbox to a short circuit in the future. Loose terminals...
Hum, or whine? Power supply still delivering 24v? (check with multimeter) Hum when moving, or while stopped (if stopped do they go more quiet...
Not true. There has always been just GND and PWM from BlackBox to Laser. Laser gets power seperately. If module only has 3 wires theres a shared...
Tool port is for the IoT relay docs:blackbox-x32:connect-dewalt-iotrelay [OpenBuilds Documentation] - its a 3.3v logic signal too Why are you...
Try CONTROL, will probably work as expected then
""
If the numbers change, it did "get the signal" Is your Gcode referenced off the correct origin (Same Zero point in CAD, CAM and Reality)
Fuses prevents fires by cutting current before wiring melts. Won't do much (not nearly fast enough) when someone wires a 24v peripheral to a 3.3v...
