Separate names with a comma.
Some features disabled for guests. Register Today.
Try a different PC, make sure you have drivers from the BlackBox docs page. Its not typical, more of a PC problem
[ATTACH]
There is a rewritten comms section in the next CONTROL update (not out yet but very soon) which may help
Inductives themselves don't react well to series/parallel wiring (active devices, does more than just a simple switch) so usually not easy to do...
When it stops, does it stop temporarily (acceleration or max rate set too high, or mechanical slippage/binding, or intermittent loose connection...
Thanks will check it out
That's not ethernet (8 pin RJ45) that's a UART on a 6 pin RJ12 https://docs.openbuilds.com/doku.php?id=docs:blackbox-x32:aux-serial Its actually...
Might be best to ask here https://github.com/grblHAL/core/issues
Yeah thats perfect, (sadly) not the cause - so still looks like PSU is the more likely cause :(
It can, though i was hoping with you for a more clear issue like a dead short in wiring somewhere, always sad when there is damage, but a relief...
Optlaser's good, so not likely to be cause. Weho's are little less filtered than the Meanwells so I would advise considering to upgrade to a...
There are testing steps in Main thing would be first to find what damaged it if its dead. Before a replacement gets damaged as well. Using our...
Will have to check the docs again, but perhaps its 0 instead of -1 that disables it.
I notice a diy RJ12 cable. Longer than ours or less shielded or similar? Interface errors look more like Serial corruption, and is likely just the...
Set A-axis Max Travel to "-1" to allow it unrestricted rotation. Normally only positive moves are in the machine envelope, to use negative spin...
The FAQ is quite comprehensive, is nothing brings it back, likely damage per Section 6.3.1 of same. Do make sure you did all the tests Like using...
They are always quite happy to help https://www.deskproto.com/webshop/contents/en-us/contactus.html if you get stuck Been a while since I did it...
1kwh usage, 6.5kwh available = theoretically 6.5hr. Lots of variables though so don't hold me to it (load on router based on cutting recipe -...
Up to 800w for Router, around 200w for machine. +-1kWh- will drain most of those banks in not a lot of time (check kWh capacity of bank)
Always here to help. All wiring covered in https://docs.openbuilds.com/blackbox-x32