Separate names with a comma.
Some features disabled for guests. Register Today.
If your wiring is OK (per Peter's post above) check your maximum speed and acceleration settings - chances are that they will need to be much...
Well the gcode cuts to Z0 and your F360 file is set with Z0 as the stock top, so something must be going wrong with your Z probe. All I can think...
Do you have homing switches installed? (If not, you need homing switches installed! :D ) Homing the machine at power up means that your...
That gcode cuts down to Z0, and no lower. How are you setting Z0 on the machine? Where is Z0 set on the Fusion CAM setup? How are you setting...
You definitely aren't the first, and probably won't be the last :D *I* wouldn't worry about wearing a stepper motor out. Higher speeds (and the...
I've just had a look for the manual: Check your DIP switches carefully! Acording to this Cloudray drive manual (I don't know if it is the same as...
Well, your maths is OK, so somehow the drive isn't set to 800 pulses/rev, or there's a gearbox or something in the drive? 10,000 pulses/mm on a...
Firstly, check that the step idle delay ($1) is 255. If a stepper motor ever loses power it will 'cog' around to its next 'natural' position....
Do you mean that the troubleshooting screen in Control shows the limit switches as red when the machine is clear of the limit switches? And they...
$5 works as a bit-map: '7' inverts all 3 axes ('1 1 1' in binary for Z Y X), '1' inverts X only (' 0 0 1' in binary) Sounds like you need to...
Under GRBL, the Reset / Abort, Feed Hold & Start (really Resume) switches are momentary. Coolant is an output.
Those look like drill bits to me, not milling cutters! :eek: If so, I'm amazed that you got as far as you did.
I've updated the original post on the other thread and deleted the spurious files from my posts above. Thanks to all for your assistance. Getting...
The GCode you posted previously cuts a line with a step in it and then stops - about 6 seconds. What are you expecting it to do? - Post your F360...
Just FYI these are the way that the F360 POST implements the lead-ins to the cut.
You can get the manual on Tekic's web site, but here is a direct link: Manual (Page 9, but read it all.)
It's difficult to tell anything from those photos (especially the supply wiring), but you do have two wires from the green plug connected to V- in...
Both of those GCode files are OK, and either should run through without problems. If your machine is stopping, it may well be EMI
I suspect that throwing the error should be the expected behaviour, but for reasons I have been unable to fathom, the same macro generates an...
Yay! The $J command was the problem. It seems that GRBL_HAL will not accept any other commands after a $J within the macro, even though standard...