Separate names with a comma.
Some features disabled for guests. Register Today.
I've checked everything with the play in the x axis so idk what is causing it to do this. Wheels are tight but not too tight and I've followed...
Now I was just looking thru the settings and for the arc tolerance setting if it was set low would it cause it to act up with trying to read the...
Yeah I feel the same way there should be a number to call. I will get to it but it is just frustrating.
Also my origin on most projects are on the left bottom corner.
Yes where my thumb and middle finger is where the flat spots are. It cleared up after I looked over everything but for the emblems I do they have...
I will do that once I get home and I can send anyone the profile cut also to test out it also to see if it's the code or the machine being the...
All that I'm doing is a vcarve toolpath for the design in the middle. Then a 1/4 profile toolpath for the cutout. Doc is .003 and the feed rate is...
I've done the steps and everything is dead on for that and I squared up the sides so it's not that. I did have the coupler loosened on the lead...
Ok I'll test it out. Just not understanding why it still has a flat spot on the x sides. I've checked over everything and idk what's causing it.
In aluminum for the square?
So still having problems again with the circles and I thought I solved the problem. I've made sure everything is not loose and honestly dont know...
Thanks and I will redo my steps again. Now the 3-4-5 how is that done? I always do when I do stuff with steps to make sure its what I had before.
Ok so I checked everything over again and think I found the problem. The coupler on the x axis was a little loose so I made sure that it was much...
Yeah I know what you mean lol I had a xcarve and when the wheels would be loose I would see the difference in cuts.
Ok I'll go thru those steps. I just made everything snug and not torquing anything down. I'll let you know on updates
Now for setting the backlash for the other plates how I would I do that?
Ok thanks I will do that and test out more possibilities.
Ok and how would I check for that?
Ok I'll check everything over and see if anything helps. I've gone thru every that I can think of but still new to the lead screw setup.
Here is the how it was cut related to the x and y axis
