Separate names with a comma.
Some features disabled for guests. Register Today.
Openbuild on fusion 360
I’m doing exactly what you are saying. Just when I go post process it. It comes up with what saying I can’t do it or whatever. Picture is shown...
Ok everyone. Hope I can get some help with this one. I tried searching. But no luck. I am trying to setup the probe. below is a picture of it. So...
josh. Your 110volt wiring that is going into the VFD. Which wire on your setup is live ( hot lead ) and which one is your neutral feed. Does it...
where can i get the original drawing or dxf files for fusion 360 of the x axis plate.
Ok. About the y axis ( 2 motors for y axis ). I have the 1510 setup. Are we adjusting both dails or just one since they are being slaved as one...
So what size rail are you using. Are th HGH15 guide rails with 15mm linear rails.
Also. To adjust the dial up. How do you know if it’s to much.
But are these rated to run off of 48 volts too.
so I have purchase the 1510 workbee with blackbox and with the high torque Nema steppers. Well doing assembling it. I have decided to upgrade my X...
Does not show any specs. Like how wide the trolley is. Yea shows how long it is. 60cm. But that not enough. Plus it does not show the actually...
You have the link to the one on amazin
Hello Jacob. Hey. So I clicked on the link for the linear rail setup you got. Well nobody had it. Not is it listed anymore on eBay. Could you tell...
Nevermind! Got it working. I never use the flash tool. Well I tryied flash tool. Bam it works now. Sorry for the delay. Thank you for each and...
how can i load the 1.1f file since my machine is a new build, so i downloaded the open control program for the first time. and my z axis will not...