Separate names with a comma.
Some features disabled for guests. Register Today.
the motors i have show to be rated at 2.5v and 2.8a.
so is there any reason why i would need to replace my stepper motors as well, or just the controller? it would be nice to have the entire kit,...
only drawback now is the part store is out of the xyz touch probe plus. :\
okay. been going through the accessories. much coolness there. however, one question. exactly how many limit switches are needed/used on a...
huge progress! i turned down the current limiters, and got the machine running much more quietly! however, on an x axis calibration using 500mm,...
so, knowing this is an incredibly subjective and **** near impossible question to answer, but what is the chance that it is not a controller...
so the blackbox controller uses 24v. i have a meanwell power supply that has 24v output. wondering if it will work, or will i need a new power...
just confirmed that the xpro v3 does have the drv8825 drivers. i've been keeping tabs on the heat sinks on those chips, and they never really got...
well, that's good information. i'll see what we can do.
My next steps will be to disconnect the coupler and jog x axis. That should rule in or out the overcurrent since wiring is good and I was very...
just checked the x axis and both coils are correctly paired, as well as correct polarity according to the wiring for that controller. will check...
i'll answer in order: i believe the motor coils are paired properly. i was very diligent in making sure of that, as that is one thing i read was...
i don't think so, but that's an easy one to double check all the couplers. it's very frustrating. i've got an issue somewhere, maybe in the anti...
sorry, missed the second part of your reponse. here are my grbl settings. every time i attempt to calibrate my x axis at this point, i get a...
how is it a wiring issue? the axes move, and in the correct direction. everything functions, just not accurately.
I appreciate that. I do disconnect them. At this point, however, I'm so frustrated that I'm just about ready to just haul it off to the trash....
To add more info, when I quickly turn the couplers at the end of the lead screw it seems like it's moving too fast for the blocks. I am using the...
So I have attempted several calibrations and have been only partially successful. The y and z axes seem fairly close but the x is giving me issues...
i'll run all this again to see what happens. just to add further information, i've also tried ugs 2.0.9, both the 32 bit and 64 bit. for some...
Considerable amount is 2 to 4 inches before I stop the machine for fear of going too far to the end of the axis. I always zero to lower left...
